Hantek DSO4204C Digital Oscilloscope 4 Channels 200Mhz PC Portable USB Oscilloscopes +EXT+DVM+Auto range function
DSO4004C Series
Technical Parameters
Model | DSO4254C | DSO4204C | DSO4104C | DSO4084C |
Bandwidth | 250MHz | 200MHz | 100MHz | 80MHz |
Horizontal | ||||
Sample Rate Range | 1GS/s | |||
Waveform Interpolation | (sin x)/x | |||
Record Length | Maximum 64K samples per single-channel; | |||
Maximum 32K samples per dual-channel (4K, 32K optional) | ||||
SEC/DIV Range | 2ns/div~100s/div | |||
1, 2, 5 sequence | ||||
Sample Rate and Delay Time Accuracy | ±50ppm | |||
Delta Time Measurement Accuracy (Full Bandwidth) | Single-shot, Normal mode ± (1 sample interval +100ppm × reading + 0.6ns) | |||
>16 averages ± (1 sample interval + 100ppm × reading + 0.4ns) | ||||
Sample interval = s/div ÷ 200 | ||||
Vertical | ||||
AD Converter | 8-bit resolution, each channel sampled simultaneously | |||
VOLTS/DIV Range | 500μV/div to 10V/div at input BNC | |||
Position Range | 500μV/div~20mV/div, ±400mV | |||
50mV/div~200mV/div, ±2V | ||||
500mV/div~2V/div, ±40V | ||||
5V/div~10V/div, ±50V | ||||
Selectable Analog Bandwidth Limit, typical | 20MHz | |||
Low Frequency Response (-3db) | ≤10Hz at BNC | |||
Rise Time at BNC, typical | DSO4254C | DSO4204C | DSO4104C | DSO4084C |
<1.4ns | ≤1.8ns | <3.5ns | ≤4.4ns | |
DC Gain Accuracy | ±3% for Normal or Average acquisition mode, 10V/div to 10mV/div | |||
±4% for Normal or Average acquisition mode, 5mV/div to 500μV/div | ||||
Note: Bandwidth reduced to 6MHz when using a 1X probe. | ||||
Acquisition | ||||
Acquisition Modes | Normal, Peak Detect, Average and HR | |||
Acquisition Rate, typical | Up to 2000 waveforms per second per channel (Normal acquisition mode, no measurement) | |||
Single Sequence | Acquisition Mode | Acquisition Stop Time | ||
Normal, Peak Detect | Upon single acquisition on all channels simultaneously | |||
Average | After N acquisitions on all channels simultaneously, N can be set to 4, 8, 16, 32, 64 or 128 | |||
Trigger | ||||
Mode | Auto, Normal | |||
Level | CH1~CH4 | ±4 divisions from center of screen | ||
EXT | 0~3.3V | |||
Holdoff Range | 20ns ~ 10s | |||
Trigger Level Accuracy | CH1~CH4 | 0.2div × volts/div within ±4 divisions from center of screen | ||
EXT | ± (6% of setting + 40mV) | |||
Edge Trigger | ||||
Slope | Rising, Falling, Rising&Falling | |||
Source | CH1~CH4/EXT | |||
Pulse Width | ||||
Polarity | Positive, Negative | |||
Condition(When) | <, >, !=, = | |||
Source | CH1~CH4 | |||
Width Range | 8ns ~ 10s | |||
Resolution | 8ns | |||
Video Trigger | ||||
Signal Standard | NTSC, PAL | |||
Source | CH1~CH4 | |||
Sync | ScanLine, LinrNum, OddField, EvenField and AllField | |||
Slope Trigger | ||||
Slope | Rising, Falling | |||
Condition(When) | <, >, !=, = | |||
Source | CH1 ~ CH4 | |||
Time Range | 8ns ~ 10s | |||
Resolution | 8ns | |||
Overtime Trigger | ||||
Source | CH1~CH4 | |||
Polarity | Positive, Negative | |||
Time Range | 8ns ~ 10s | |||
Resolution | 8ns | |||
Window Trigger | ||||
Source | CH1~CH4 | |||
Pattern Trigger | ||||
Pattern | 0: Lower level; 1: High level; | |||
Level | CH1~CH4 | |||
Interval Trigger | ||||
Slope | Rising, Falling | |||
Condition(When) | <, >, !=, = | |||
Source | CH1~CH4 | |||
Time Range | 8ns ~ 10s | |||
Resolution | 8ns | |||
Under Amp | ||||
Polarity | Positive, Negative | |||
Condition(When) | <, >, !=, = | |||
Source | CH1~CH4 | |||
Time Range | 8ns ~ 10s | |||
Resolution | 8ns | |||
UART Trigger | ||||
Condition(When) | Start, Stop, Data, Parity Error, COM Error | |||
Source(RX/TX) | CH1~CH4 | |||
Data format | Hex | |||
Condition(When) | <, >, !=, = | |||
Data Length | 1 byte | |||
Data Length | 5 bit, 6 bit, 7 bit, 8 bit | |||
Parity Check | None, Odd, Even | |||
Idle Level | High, Low | |||
Baud Rate(Selectable) | 110/300/600/1200/2400/4800/9600/14400/19200/38400/57600/115200/230400/380400/460400 bit/s | |||
Baud Rate (Custom) | 300bit/s~334000bit/s | |||
LIN Trigger | ||||
Condition(When) | Interval Field, Sync Field, Id field, Sync Id Error, Identifier, Id and Data | |||
Source | CH1~CH4 | |||
Data format | Hex | |||
Baud Rate (Selectable) | 110/300/600/1200/2400/4800/9600/14400/19200/38400/57600/115200/230400/380400/460400 bit/s | |||
Baud Rate (Custom) | 300bit/s~334000bit/s | |||
CAN Trigger | ||||
Condition(When) | Start Bit, Remote Frame, Data Frame Id, Frame Id, DataFrame Id A, Error Frame, All Error, Ack Error, Overload Fram | |||
Source | CH1~CH4 | |||
Data format | Hex | |||
Baud Rate (Selectable) | 10000, 20000, 33300, 500000, 62500, 83300, 100000, 125000, 250000, 500000, 800000, 1000000 | |||
Baud Rate (Custom) | 5kbit/s~1Mbit/s | |||
SPI Trigger | ||||
Source (CS/CLK/Data) | CH1~CH4 | |||
Data format | Hex | |||
Data Length | 4, 8, 16, 24, 32 | |||
IIC Trigger | ||||
Source (SDA/SCL) | CH1~CH4 | |||
Data format | Hex | |||
Data Index | 0~7 | |||
When(Condition) | Start, Stop, No Ack, Address, Data, Restart | |||
Inputs | ||||
Input Coupling | DC、AC or GND | |||
Input Impedance, DC coupled | 20pF±3 pF,1MΩ±2% | |||
Probe Attenuation | 1X、10X | |||
Supported Probe Attenuation Factors | 1X、10X、100X、1000X | |||
Overvoltage Category | 300V CAT II | |||
Maximum Input Voltage | 300VRMS (10X) | |||
Measurements | ||||
Cursors | Voltage difference between cursors: △V Time difference between cursors: △T Reciprocal of △T in Hertz (1/ΔT) | |||
Automatic Measurements | Frequency, Period, Average, Pk-Pk, RMS, PeriodRms, Min, Max, RiseTime, FallTime, + Width, - Width, + Duty, - Duty, Vbase, Vtop, Vmid, Vamp, Overshoot, Preshoot, PeriodAvg, FOVShoot, RPREShoot, BWidth, FRR, FFF, FRF, FFR, LRR, LRF, LFR and LFF | |||
General Specifications | ||||
Display | ||||
Display Type | 7 inch 64K color TFT (diagonal liquid crystal) | |||
Display Resolution | 800 horizontal by 480 vertical pixels | |||
Display Contrast | Adjustable | |||
Probe Compensator Output | ||||
Output Voltage, typical | About 2Vpp into ≥1MΩ load | |||
Frequency, typical | 1kHz | |||
Power Supply | ||||
Supply Voltage | 100-120VACRMS(±10%),45Hz to 440Hz,CATⅡ 120-240VACRMS(±10%),45Hz to 66Hz,CATⅡ | |||
Power Consumption | <30W | |||
Fuse | T,3.15A,250V,5x20mm | |||
Environmental | ||||
Operating Temperature | 0~50 °C (32~122 °F) | |||
Storage Temperature | -40~+71 °C (-40~159.8 °F) | |||
Humidity | ≤+104℉(≤+40°C): ≤90% relative humidity | |||
106℉~122℉ (+41°C ~50°C): ≤60% relative humidity | ||||
Cooling Method | Convection | |||
Altitude | Operating and Nonoperating | 3,000m(10,000 feet) | ||
Random Vibration | 0.31gRMS from 50Hz to 500Hz, | |||
10 minutes on each axis | ||||
Nonoperating | 2.46gRMS from 5Hz to 500Hz | |||
10 minutes on each axis | ||||
Mechanical Shock | Operating | 50g, 11ms, half sine | ||
Mechanical | ||||
Dimension | 318 x 110 x 150mm(L x W x H) | |||
Weight | 2900g |
Arbitrary Waveform Generator Mode | ||||
Waveform Frequency | Sine: 0.1Hz~25MHz Square: 0.1Hz~10MHz Ramp: 0.1Hz~1MHz EXP: 0.1Hz~5MHz | |||
Amplitude | 5mV~3.5Vp-p(50Ω) 10mV~7Vp-p(High impedance) | |||
DAC | 2K~200MHz adjustable | |||
Frequency Resolution | 0.001 | |||
Channel | 1CH waveform output | |||
Waveform Depth | 4KSa | |||
Vertical Resolution | 12 bit | |||
Frequency Stability | <30ppm | |||
Output Impedance | 50 Ω |
Product Image
Function Image
Shipping:
We will ship all items within 1-3 working days upon receipt of payment,our goal is: send faster and been received earlier .
Expedited/Standard Int'l Shipping by Fedex,DHL,TNT and EMS courier: To USA,need 3-6 business days,To other countries,need 4-8 business days normally.But sometimes int'l delivery is highly depended on the courier company and local customs/duties.
Import duties and taxes are not included in the item price or shipping charges.These charges are the buyer responsibility.
Warranty&Return Policy:
We encourage all customers to communicate with us through eBay messages.
If you have any questions or comments whatsoever regarding our products or listing, we are waiting to hear from you
A 1 year warranty is offered for this product.If the product malfunctioned under proper usage per instructions
manual within the warranty period, please contact us to obtain shipping instructions and send it back at your shipping costs.
30 days evaluation and investigation takes placed after receiving your return item.A brand new replacement unit will be sent to you at our shipping costs if it meets our warranty