Up for your consideration is a set of 16 slider pots for the Roland Juno 106 Panel Board. These are new, not refurbs.

Note about the Slider Pots. (GEEK ALERT:) If you have read the blogs and such about the slider pots available these days, you'll know that one of the complaints is that the lever, the part that your knob attaches to, is undersized. Two major reasons that contribute to this: 1) Even though there are multiple sites offering this part, there are only two or three manufacturers in the world who actually make it. For the most part, they get their component parts from a small pool of suppliers. The levers that are available today are slightly under size. For you technical folks, the spec is 1.2 mm. The parts coming out of the factories these days are 1.15-1.18mm We are talking about fractions of a millimeter. Doesn't sound like much, but that leads us to factor number 2) Many of the knobs have been removed and replaced over the years. I know that when I was playing and recording with my first Juno years ago (yes, I'm that old) I would mindlessly remove and replace the knob while I was bored. What happens is that the soft plastic wears away very quickly. What you are left with is a new lever that is undersized and an old knob that is now over sized. Yep, you know where this is going. Is doesn't stay on the lever. So why did I tell you all this, because when you order the sliders from us, you will see a small bump toward the top of the lever. We have this added manually on each one. This creates a "high point" on the lever, which causes a tight fit on the old knobs. So two take aways: 1) no the levers are not used, we have them made that way, and 2) to our knowledge we are the only seller on eBay or anywhere else that goes to the trouble to do this. We believe that is a win-win for everyone.

We also have the set of three, 20mm sliders for the Bender board available in another listing.