THESE ARE FURNACE BLOWER ASSEMBLIES, REMOVED FROM CENTRAL AIR GAS FURNACES.

WE WILL HELP YOU WITH TECH SUPPORT AND SIZING TO GET YOU THE RIGHT BLOWER

WE HAVE A WIDE VARIETY OF BLOWER ASSEMBLIES

Just send us a message with your:

Intended use for the blower

If you need a specific size, please provide:

Width (flat surface to flat surface)

Outlet opening width (should be the same as blower width) and length

Blower height and length

AC size

BTU size for gas furnace replacement

• 120 VOLT UNITS
• THESE INCLUDE A BRAND NEW MOTOR INSTALLED ON A USED ASSEMBLY
• SQUIRREL CAGE, MOTOR, AND HOUSING ASSEMBLY
• VERY POPULAR FOR USE AS SHOP FANS AND VENTILATORS
• 120 VOLT FOR EASY PLUG-IN WIRING
• I HAVE SEVERAL, YOURS WILL VARY FROM PICTURE
• MOST ARE 3 TO 5 TON (AC) SIZE
• NEED A SPECIFIC SIZE TO REPLACE YOUR EXISTING FURNACE ASSEMBLY? CONTACT ME WITH OPENING DIMENSIONS, AND I'LL MATCH AS CLOSE AS POSSIBLE.
• RUN TESTED AND WORKING GOOD

REPLACEMENT BLOWERS

FOR THOSE LOOKING FOR A BLOWER TO REPLACE YOUR EXISTING GAS FURNACE BLOWER:

TECH TIP;

MATCH THE WIDTH, MATCH THE BLOWER

TYPICALLY, ALL BLOWERS HAVE THE SAME DIMENSIONS, EXCEPT AS THE BLOWER GETS BIGGER, IT GETS WIDER

MOST ALL BLOWERS HAVE AN AIR OPENING THAT IS 11 1/2 TO 12 INCHES LONG.

BUT THE AIR OPENING WIDTH, WHICH IS THE SAME AS THE BLOWER HOUSING WIDTH, IS ABOUT 8 INCHES IN A 2 TON, 50,000 BTU FURNACE BLOWER, GOES TO 16 INCHES IN A 125,000 BTU, 5 TON BLOWER. THE RADIAL DIMENSIONS GET A BIT LARGER AS THE BLOWER GETS LARGER, TOO

PLEASE PROVIDE THE OLD BLOWER WIDTH, SO IT CAN BE MATCHED AS CLOSE AS POSSIBLE. BLOWERS WITH MATCHING WIDTH HAVE MATCHING CFM CAPACITY, SO A SIMILAR WIDTH BLOWER WILL WORK.

THE REPLACEMENT BLOWER MAY NOT BE EXACT, SO SPECIAL MOUNTING MAY HAVE TO ADDED TO SECURE THE BLOWER