 |
|
|
| |
 |
| |||
 |
|
 |
| |
| ||||
 The DynoTune Time Delay Relay (DTDR) can be used to control just about anything you need with time delay. The operation is very simple, apply 12 volts to the white trigger wire and after the time delay relay counts down and turns on, the internal relay inside turns on! You can run 12v though these terminals, you can run a ground
though them etc… Adjust the digital display as needed. The time delay can work
with an auto or manual transmission. During the shifts with a manual
transmission the timer will keep track where its at in the time ramp.. it will
not reset back to zero unless you shut the main power off to the red wire, then
it will reset the time delay. Any time
you lift off the gas and get back into it the timer continues its time ramp… until
the time is reached and the internal relay turns on. NOTE: The Terminals are only
good for 5 amps of current so you might need to use another relay!! Drawing to
much current through these contacts will activate the internal fuse and it will
not function until the power is reset. Mount
the timer in a cool dry location. Wires: RED
--- switched +12V BLACK
--- battery ground only WHITE
--- +12v applied to start trigger/timer BROWN---
common for internal relay ( you can run this to switched +12v or a battery
ground depending on what device your trying to activate) YELLOW
--- Normally Open ( connects to common wire when time delay is triggered and
time is reached) PINK --- Normally Closed ( this pink wire is always connected to the brown common wire until the time delay is triggered and time is reached, at that point this connection breaks and the wire is no longer connected to the brown common wire. When the time delay box is powered back off it reconnects the pink wire to the brown wire and is ready to work again.) The
left push button changes the X. setting
X.XX The
Right push button changes the .XX
setting X.XX
After you make a change the display will stop flashing and lock on and be ready to work. Max delay setting is 9.99 secondssize: 2"x2"x1.1" Comes with great wiring directions and examples...simple to install.
The Kit contains the following:
|
