The P1000X5 1,000 Watt full-range 5-channel is the one-and-only amplifier you will need to run your entire system. Run dash speakers off the front channels, run back speakers off the rear channels and run subwoofer(s) off the 5th channel! Known world-wide for brute power, this amplifier offers a higher level of efficiency along with a tri-stage protection that covers thermal, over-current and short circuits.

  • High level input capable with Auto Turn-On circuit
  • Features C.L.E.A.N. Set-up
  • Optional remote Punch Level Control (PLC2) ready (w/ input clip indicator)
  • 12dB/octave Butterworth crossover
  • On-board Punch EQ with +18dB boost @ 45Hz
  • Muted turn on
  • Stealth top mounted control panel
  • Cast aluminum heatsink
  • Short circuit protection
  • Over current protection
  • Infrasonic filter
  • 2/4 channel input switch

Number of Channels
5
Total Power 
(Sum of Rated Power)
1000 Watts
Rated Power 
(RMS Continuous Power)
75 Watts x 4 + 
150 Watts x 1 @ 4-Ohm 

125 Watts x 4 + 
300 Watts x 1 @ 2-Ohm 

N/A + 
500 Watts @ 1-Ohm
Dynamic Power 
(PVC/PowerCube®)
115 Watts x 4 + 
299 Watts x 1 @ 4-Ohms 0° Res 

190 Watts x 4 + 
540 Watts x 1 @ 2-Ohms 0° Res 

N/A + 
863 Watts x 1 @ 1-Ohm 0° Res
Bridgeable
Yes (front/rear channels)
Frequency Response
Front/Rear: 20Hz - 20kHz +/-3dB 
Sub: 20Hz - 500Hz +/-3dB
Input Sensitivity
150 mV - 12 V
Circuit Topology Class
Class A/B + Class BD (Sub)
Efficiency (average)
Front/Rear: 66% @ 4-Ohm 
Sub Channel: 80% @ 4-Ohm
Total Harmonic Distortion (THD+Noise)
<1.0%
Signal Input
Input Switch: Hi/Low level input 
Input Switch: 2/4 channel input 
Hi/Low Level: 3 RCA Pair 
Sub: front/sub input switch
Signal Output
-
Tone Controls
Sub: 
0dB to +18dB @ 45Hz
Crossover Controls
Front: 50Hz - 250Hz High-Pass @ 12dB/Octave 
Rear: 50Hz - 250Hz High-Pass @ 12dB/Octave 
Sub: 50Hz - 250Hz Low-Pass 
Sub: 28Hz infrasonic filter @ 12dB/Octave
Remote Controls
Optional Punch Level Control (PLC2) Ready
Visual Indicators
Power/Protect/Thermal LED 
Input Clip LED3 
Output Clip LED1,2,3 

LED Color Legend: 
1BLUE: <0.5% THD 
2VIOLET: 1% THD 
3RED: 10%+ THD
Power Wire Gauge
4 AWG
Power Input Connector
Block
Speaker Wire Gauge
12 AWG
Speaker Output Connector
Block
Cooling
Convection
Heatsink
Operating Voltage
9 - 16 VDC
Recommended Fuse 
(not included)
150 A
Average Current Draw (13.8V Music)
75 A
Max. Current Draw (13.8V Sinewave)
150 A
Suggested Alternator
100 A
Dimensions (H x W x D)
2.38 x 7.76 x 15.03 (in) 
6.05 x 19.71 x 38.18 (cm)