For sale is a large STEARMAN AIRCRAFT brass font plate for a new Hermes engraver. This may also be used as a decorative wall hanging.

For those that are using this for engraving please note that the sand in the hourglass and the letter S have been completely milled away with a special milling cutter to allow you to waste away all of the material if you are duplicating this in plastic.

One of the photographs shows this template mounted on one of the smaller desk top style machines. Please be aware that this is a larger template and it is better suited for the larger TX or GTX style machines. Any of the larger machine's offer plenty of room for this template to work.

This is so large it will not slide into the copy tray. It is mounted to your copy stops using the included hardware package and wrench

You unscrew your brass thumbscrews and then insert the stainless steel set screws. Leave them loose and then place the template over the set screws which will automatically set the spacing. Then lightly tighten the set screws with the hex wrench. Then just add the brass thumb nuts and tighten it.


This will be sandwiched in between two pieces of Louan plywood to protect this from damage during shipping. This will be mailed in a padded flat rate priority envelope with free tracking and insurance.

If you pay by noon I will also mail the same day for faster service. Thank you for looking.

PLEASE NOTE THAT THE HARDWARE KIT THAT IS SUPPLIED HAS FINE THREAD METRIC HARDWARE (5MM .8 PITCH). THIS FITS 99% OF THE MACHINES IN CIRCULATION. HOWEVER THERE ARE A FEW MACHINES OUT THERE THAT USE A (SAE) #10-24 UNC AMERICAN PITCH THREAD ON THE COPY STOPS. IF THIS IS YOU PLEASE REQUEST THE 10-24 HARDWARE KIT WITH YOUR PLATE OR THE METRIC VERSION WILL BE INCLUDED BY DEFAULT.

IF YOU ARE UNSURE OF WHICH THREAD YOU HAVE PLEASE CONTACT ME AND WE CAN FIGURE IT OUT TOGETHER.