This is hand assembled by me using components from my popular Deluxe VTVM probe kits sold here on eBay, using my methods and good attention to detail.

The unit is presented in a Labeled, Retail Quality, Reusable, 4 Mil Poly Ziplock Bag and is wrapped with a Reusable Velcro Strip to keep the leads organized and ready.

This dual probe setup,  serves as a substitute for the mostly missing or incomplete original test probe which used a switch at the tip of the probe to switch the Resistor in/out of the circuit.

This Siamese or Dual-Probe arrangement involves using one probe for DC Measurement (with the resistor installed) and the other probe for AC/Ohms Measurement.

The probes are built from the following components:

1 Pair of Genuine Philmore Test Probes - 1 Red/1 Black

1 1/4" Mono Phone plug connector with heat shrink Sleeve

1 1 Meg Ohm 1/2 Watt Resistor

1 Alligator Clip & Heat Shrink Tubing

2 Laminated Self Adhesive Probe Labels and Clear Heat Shrink Tubing to cover the probe labels, resulting in a professional and durable setup (see photos)

2 36" lengths of RG174 Coaxial Wire (used for DC & AC/Ohms test Leads) (Very Flexible - makes a great test lead) 

1 36" Length of 18 Gauge Rubber Test Lead Wire (Very Flexible - High Quality) for the Ground Lead

1 Banana Plug

The original instructions specify shielded cable for the leads, the original supplied wire was a coaxial microphone style wire, many people use either standard (unshielded) test probe wire for the leads or a shielded coaxial cable, I use shielded black RG174 for the 2 leads and Black test probe wire for the ground - this is particularly important for this meter