REVISION (10/16/2018): I just noticed that the product detail eBay listed here is incorrect. This unit is the 4S which means the build area is 400x400x400 mm not the 300x300x400mm listed above. Also I put the original white tubing back on but the blue tubbing will be included. Also the first picture is a stock photo that eBay put on. That is not my unit.
This auction is for a Creality CR-10 4S 3D printer. The print area is just under 16 inches cubed!
This is a great first 3D printer especially as a work horse printer. There are lots of you tube videos about this printer.
This unit has about 150 print hours on it. It is being sold as is as it needs to be recalibrated. This unit has the dual z axis stepper motors Also recommend you add new firmware (See TH3D website for free downlaod). See the list below for the details. See photos of unit. No filament is included.
ADD-ONS
upgraded TH3D Extruder Feeder hardware (old pieces included)
Added vertical (Z-axis) supports
New Boden tube
Extra boden tubing and fittings
New nozzle (0.4mm)
Three other new nozzles (different sizes)
16 inch square mirror Printing surface very flat!
TH3D EZMAT build sheet (not installed)
Still has original firmware
Have instructions which are poor
TAKE AWAYS (mostly minor stuff)
unit needs extruder calibration
May want to replace boden tubing
Y axis belt tightener modified (can be reset)
Still has original firmware
Some assembly required
My opening bid is low as this unit sells new for about $600.
I will take the unit’s tower off so it’s easier to ship. So some assembly will be required.
Please remember this is being sold AS IS.
Shipping is a flat $25 for the continental USA. OTHERS PAY ACTUAL SHIPPING COST.