------------------------------------------------------------------------------------------------------------------------------------------------- Bondhus Extra Long Ball Drivers with ProGuard Finish 10.5" blades.
Your order also ships with one Stainless Steel Telescoping pick-up and positioning Tool (5 inches to 26 inches) with a strong Neodymium magnet.
This is truly a lifetime investment in the best extra long ball drivers available anywhere:
Sizes available 7/32, 1/4, 5/16, 3/8 inch. And 5mm, 6mm, 8mm, and 10mm.
This offering presents a good value.
Ball End inserts into screw at a 25° angle
Ergonomic handle design
Non-slip grip
Two component handle with tough inner core and cushioned rubber exterior
Anti-roll designHere are Large sizes needed for full scale cars, equipment and machinery, tractors, trucks, motor homes, trailers, full scale airplanes and more. Offers the extra reach and a 25 degree entry. Made from top quality chrome vanadium steel with a black oxide finish. These deluxe, top-of-the-line ball drivers are heat treated in carefully controlled conditions for consistent performance. Precisely-sized ends are chamfered to slide easily into fastener, reducing wear on the ball driver and damage to fastener head. These are the best ball drivers money can buy....truely a life-time investment, and a real pleasure to work with.
No screw will be out of reach! Here's my personal true story that many folks will relate to: "For many years I didn't have these long ball drivers. I remember how many times I wish I did. I recall losing an airplane because I was too lazy to take the cowl off to check the tightness of the engine mounting bolts. I remember taking the spinner off and seeing that I could actually get to the engine mounting bolts at about a 10 degree angle but they were about seven or eight inches in, and there was no way any ball driver that I had would reach that far. Well long story short, the engine mounting bolts were loose and I lost the plane. Bam $1,000.00 gone!" Rich, RTL Fasteners..."30 years in the hobby and still learning.....sometimes the hard way!"