Cree 5 Watt XP-G3, XPG3 LED Bulb Torch FOR Sears Work Lights Craftsman C3 19.2 V

------ NEW Cree XPG3 UPGRADED FROM our previous Cree XPG2 *******

Cree® XLamp® XP-G3 LED Delivers More Lumens-Per-Watt

Use this 320 LUMEN LED Bulb to upgrade Sears Craftsman Lights

Our Cree 5 Watt LED Bulb for Sears is 320 Lumen LED which was tested for direct compatibility in the C3 light. We found Craftsman C3 light construction with all plastic holder makes LED run hotter than other lights and can damage ordinary 5-W LEDs by over-heating. (We add heat conductive spacer or compound on this LED to improve heat dissipation for you). Also, please exercise care in changing bulbs as plastic lens / bulb retainer of the C3 can be damaged by ruff re-assembly.

We also recommend for the C3 light the Epistar 3-Watt 250 Lumen LED. This LED is also bright, efficient, very long battery run time, cool running, and long life bulb that may never need replacement.

Epistar LED Bulb 3 Watt 250 Lumen Cool Long life FOR Sears Craftsman C3 19.2 V Lights

https://www.ebay.com/itm/232700958698

for superior brightness, efficiency, and longevity for Less ---

LED UPGRADE For the Following Rechargeable Work lights and Replacement Bulbs:
Work Light Upgrade For:			Bulbs Upgrade For:
Sears Craftsman	911391 009-11391 315.113913	19.2v	Sears Craftsman	911009	16.8v-18v
				911213	19.2v
Sears Craftsman is a registered trademark of KCD IP, LLC, Draco Products is not affiliated with KCD IP, LLC

Simply replace your existing bulb with this LED – no modifications necessary!

*Please note, This is the brightest Cree XPG3 LED bulb for Sears replacing the old Krypton or Xenon bulb.

Universal Voltage Works with standard flashlights and Work Lights 9 Volt to 30 Volts
Standard DC Polarity (+) on bottom contact or Flange !
Minimizes battery and bulb replacement waste
Focusability of flashlight is preserved with these point source LEDs
Brighter Light for improved vision for enhanced visibility of fine detail
Longer battery life from high efficiency LED
Long lamp life 50,000 hours of continuous use
Dependable and shock resistant
Easy To Install

Features:

INTENSE BRIGHT LIGHT output comes from the ultra-efficient LED. The LED does not fade when it gets hot, so its light output is stable even after extended run times.

FOCUSABILITY These LED Point source lights preserve one of the most outstanding features of many flashlights, the ability to focus. A focused beam that throws a bright beam a very long distance.

MAXIMUM EFFICIENCY These LEDs are powered below their maximum rating for longer life and higher lumens per watt of battery power.

LONGER BATTERY LIFE results from the higher efficiency of the LED compared to the standard incandescent bulb 10 Lumens / watt. These LED maintain a brighter white light output as the batteries discharge than incandescent bulbs which turn to an amber light.

INDESTRUCTIBLE LED performance and lifetime operation. Unlike incandescent bulbs with a thin fragile filament that breaks, LEDs wear out very slowly. This is likely to be the last bulb you will ever need to buy. The rated lifetime is 50,000 hours.

EASY TO INSTALL as if just replaces your existing bulbs - no modifications necessary

Standard PR Incandescent vs. LED

See the difference!


	1) Warning! - Do not look directly into lit LED Lamps at a close distance or shine into eyes, as they are extremely bright and could cause eye damage.

	2) Warning! - For safety always follow manufactures safety and operational instructions.

	3) Caution! - Remove batteries, turn-off or disconnect power before changing bulb.

* The perfect bulb (High Brightness and Longer Battery life run time).

This Cree is a Point sorce LED (Better were focused light is desired) and the Epistar in other add below is a diffused LED (Wide angle area Light is desired).

See my other add for more details.

https://www.ebay.com/itm/Epistar-Cree-LED-Flashlight-Bulb-Upgrade-Universal-5V-30VOLT-4-Cell-N-Up-Work-/231314842982?ssPageName=STRK:MESE:IT#ht_3349wt_789

Upgrade / Replacement for standard Work Light applications that take a flange base light bulb for 9-30 Volt battery operated products (Zink, Alkaline, lithium, NiCad).

*EPISTAR is a trademark of EPISTAR Corporation
*CREE is a trademark of Cree, Inc.
* Draco Products is not affiliated with Epistar Corporation or Cree, Inc.

☛ · Buy two now and save with discounted shipping, the right bulb is hard to find, why not get two?

This is a very popular style of bulb for Many Work Lights, flash lights, and work lights

Standard Polarity LED with bottom contact Positive!

*Specifications are accurate for this Miniature LED Bulb. Applications for this standard Flange type bulb are too numerous to list so purchaser is responsible for compatibility with their actual product.
The Lamp has a STANDARD 'PR' Base - P13.5s is International standard flanged base, 9.2mm Diameter, with flange "V" notch

"There are 100's of satisfied customers on this LED type alone.

by dfar2069Dec 25, 2018

Best bulb for flashlight

I waited for this review to come to my email. I have to say this is the brightest I’ve ever seen from my flashlight. This bulb is much better than I expected.

Verified purchase: Yes | Condition: New | Sold by: draco-product

(0)

(1)

by 4jbsMay 30, 2019

very bright

is a quality product

Verified purchase: Yes | Condition: New | Sold by: draco-product

(0)

by mosl-tonAug 26, 2018

cree 5watt led.

man this bulb is a great replacement for the craftsman c3 light its bright led

Verified purchase: Yes | Condition: New | Sold by: draco-product