This offer is for 1 Universal Joint.
Fits:
Please do not make any
assumptions as far as fitment is concerned. You must verify that this part will
fit your exact model and specifics by doing the following:
1) See the table
below if your model is included. If so, then
2) Go to the
compatibility chart of the listing above. If you can’t see the
compatibility chart, then click on “see compatible vehicles” at the top of the
listing to display the chart.
3) Locate your vehicle
in the chart by year, make, model….etc.
4) The left most
column, is the notes column with important details. Any restrictions or
specifics for which this part will or will not fit will be included in these
notes.
In general, the drive
of your vehicle (4WD, AWD, ….etc) needs to be known. Also how many drive
shafts does your vehicle have? On which drive shaft you want to install the
U-Joint and where on that shaft (front, rear, at transmission….etc.)
BUICK | 1961-1962 |
CADILLAC | 1957-1962 |
CHECKER | 1969-1977 |
CHEVROLET | 1968-2012 |
CHRYSLER | 1965-1973 |
DODGE | 1966-2010 |
FORD | 1963-2014 |
GMC | 1968-2012 |
ISUZU | 2006-2008 |
JEEP | 1994-2007 |
LINCOLN | 1963-2008 |
MAZDA | 1994-2009 |
MERCURY | 1964-2010 |
MITSUBISHI | 2006-2009 |
NISSAN | 2005-2015 |
OLDSMOBILE | 1968-1970 |
PLYMOUTH | 1966-1967 |
RAM | 2011-2013 |
SUZUKI | 2009-2012 |
TOYOTA | 2005-2015 |
|
Specifications | |
---|---|
Bearing Cap Axis 1 Diameter - Inch | 1.063 |
Bearing Cap Axis 1 Diameter - mm | 27.0 |
Bearing Cap Axis 2 Diameter - Inch | 1.063 |
Bearing Cap Axis 2 Diameter - mm | 27.0 |
Bearing Cap Type | 4 Round Plain Bearings |
Bearing Diameter A - Inch | 1.063 |
Bearing Diameter A - mm | 27.0 |
Bearing Diameter B - Inch | 1.063 |
Bearing Diameter B - mm | 27.0 |
Bearing Type A | Round Plain |
Bearing Type B | Round Plain |
Greasable | Yes |
Length A - Inch | 3.62 |
Length A - mm | 91.9 |
Length Axis 1 - Inch | 3.62 |
Length Axis 1 - mm | 91.9 |
Length Axis 2 - Inch | 3.62 |
Length Axis 2 - mm | 91.9 |
Length B - Inch | 3.62 |
Length B - mm | 91.9 |
Length Measurement A | Outside of Bearing To Outside of Bearing |
Length Measurement B | Outside of Bearing To Outside of Bearing |
Lube Fitting Location | Flush-type lube fitting in bearing |
Lubricateable | Yes |
OE Series | Spicer 1330 |
U-Joint Identification | 4 Round Plain Bearings |