RFX Race Series Kill Switch / Button

Exact replica OEM replacement part. Complete with the

same couplings, fasteners, connectors and exact cable lengths as the genuine part.

• OEM replacement
• Accepts all original connectors
• OEM cable length

Fitting Instructions

• Start      by removing the front number plate.
• Carefully      snip any cable ties holding the start and stop switch cables to the bars      then un-screw the clamps and let these hang down.
• Locate      the connector for the switch on the bike, these are often close by to the      headstock on the chassis but sometimes can be under the tank.
• Unclip      the connector and remove the switch taking a note of the routing for the      wiring.
• Clean      the connector using contact cleaner such as Maxima Electrical Contact      cleaner.
• Loosely      attach the new switch on to the handlebars in the desired position.
• Route      the wires as per the old switch and clip the connector together.
• Check      all free pay in the wires by turning the bars to full extension and making      sure the wires don’t pull tight, adjust if necessary.
• Re-fit      cable ties to the wires if possible positioning the cables to the back of      the bars to prevent damage from roost.
• Re-fit      your number plate.