Ortur Laser Master 2 - Air Assist.
Smoke coming from your engraved surface can get on your laser's lens. A dirty lens equals poor engraving. So, make sure to keep your lens clear for clean, even burns. Our air assist rids the desired surface of debris and also keeps smoke off your laser's lens. Get deeper cuts by removing the debris with air assist, cleaner engravings and overall better performance. If you have shop air that is recommend between 15-25psi. Small pumps will show great improvement as well but not as good as the larger pumps. If you need pump recommendations, send us a message.
** This listing comes with Air Assist plus 6 feet of air pump hosing to connect to your air pump.
Install:
Fasten attachment bracket to module using provided screws
Attach adjustable links to one another and attach the air nozzle to the last link
Hose attachment goes into open joint on other side of the attachment bracket
6 feet of silicone hose to connect to your air pump. Secure with zip-ties along wire harness
King Gubby Designs has been solving problems for lasers printers for a few years now. When we encounter a consistent problem or design flaw with a machine we use, we get to work coming up with a solution. This product is one of those solutions.
We hope you enjoy it.
- The laser and hose shown is for illustrative purposes only and is not part of the offer.