Audi S3 8Y 2020 onwards Exhaust Valve Electrical terminator connector ( 3 PIN )

If you own the latest S3 you will know that they are much quieter compared to the pre WLTP vehicles, this modification safely keeps the exhaust valves permanently open.

Advert is for 2x 3 pin modules and 2x 3 pin blanking connectors.

The connectors allows you to terminate the wiring loom once disconnected from the exhaust module to eliminate soft fault codes appearing, supplied blanking connectors eliminate water ingress in what will be redundant exhaust valves.

Unlike the factory setup, even in dynamic mode the exhaust valve doesn't fully open throughout the complete rev range. As soon as you pull off the exhaust valve closes

and only reopens above 3000rpm, by caring out this modification you get a deeper note lower down in the rev range.

Fitment -

Simply disconnect the connector the harness connector from the modules then connect the purchased component (Modules) into the wiring harness. blanking plugs into the exhaust module.

These connectors are Poke Yoke so it's impossible to fit incorrectly

Any questions, please get in touch and I’ll be happy to help