MA5532 AS3935 Breakout Board Lightning Thunder Storm Distance Detector Sensor
AS3935 Lightning Detector
GY-AS3935 AS3935 Light-ning Detector Digital Sensor Breakout Board Module SPI I2C Thunder Storm Distance Detection
Description:
Based on the AMS reference design, this is the AS3935 digital sensor breakout board.
This innovative sensor features a specially tuned antenna, SPI or I2C interface, designed to interface with most current development systems and boards.
The splitter uses an inductor (antenna) designed specifically for this application, and the board is fully calibrated.
This ensures that you can support low-level IC calibration without having to write a large back-end - focus on your end application!
Features:
Detects cloud-to-cloud and cloud-to-cloud flashes
The estimated strike is between 14 and 40 kilometers
Embedded "artificial" interference suppression algorithm
Thunder and detection threshold is programmable (such as outdoor to indoor)
Wide supply voltage range: 2.4V - 5.5V
SPI and I2C operations are supported by default, I2C Address 0x03
Split board ship fully calibrated
Application:
Weather station
Sports electronic equipment
Phone
smart watch
Golf equipment
Package Included:
1 x AS3935 Lighting sensor
Connection
* Arduino Uno Arduino Mega --> SEN-39001: AS3935 Breakout
* SDA: SDA SDA --> MOSI/SDA (SDA is labeled on the bottom of the Arduino)
* SCLK: SCL SCL --> SCK/SCL (SCL is labeled on the bottom of the Arduino)
* SI: pin 9 pin 9 --> SI (select interface; GND=SPI, VDD=I2C
* IRQ: pin 2 pin 2 --> IRQ
* GND: GND --> CS (pull CS to ground even though it's not used)
* GND: GND --> GND
* 5V: 5V --> Arduino I/O is at 5V, so power board from 5V. Can use 3.3V with Due, etc
* SCLK: SCL SCL --> SCK/SCL (SCL is labeled on the bottom of the Arduino)
* SI: pin 9 pin 9 --> SI (select interface; GND=SPI, VDD=I2C
* IRQ: pin 2 pin 2 --> IRQ
* GND: GND --> CS (pull CS to ground even though it's not used)
* GND: GND --> GND
* 5V: 5V --> Arduino I/O is at 5V, so power board from 5V. Can use 3.3V with Due, etc
