Ford Focus Mk3 RS Exhaust Valve Delete And Blanking Terminator connector OEM
This is designed to connect into the exhaust valve harness side to eliminate the soft fault code found when disconnecting from the exhaust module and blanking plug to eliminate water ingress in the module.
These will allow the exhaust valve to be permanently open for a deeper exhaust note.
Unlike the factory setup, even in dynamic mode the exhaust valve doesn't fully open throughout the complete rev range. As soon as you pull off the exhaust valve closes and only reopens above 3000rpm, by carrying out this modification you'll get a deeper note lower down in the rev range.
OEM connectors
1x valve delete connector supplied
1x blanking connector
Fitment - Simply disconnect the connector from the exhaust valve module, and plug in the connectors. Procedure carried out with the ignition off and keys out of the vehicle, These are poke yoke so it is impossible to fit them incorrectly.