Audi RS6 RS7 C7 4.0tfsi Exhaust Valve Electrical terminator connectors

A couple of reasons exhaust valve terminators are required.

1. If your looking to keep the exhaust valves permently open to aid a deeper exhaust note low down in the Rev range or have a faulty exhaust valve and not wanting to fork out a expensive repair.

2. If you using a aftermarket backbox without exhaust valves fitted. If so you will only require the exhaust valve modules (see other listing for either valve modules or blanks individually)

The connectors allows you to terminate the wiring loom once disconnected from the exhaust module to eliminate soft fault codes appearing.

Fitment -

Simply disconnect the connector from the exhaust valve and connect the purchased component into the wiring harness. blanking plugs into the exhaust module.

These connectors are Poke Yoke so it's impossible to fit incorrectly

Please check compatibility with your vehicle before purchase, These are a 3 pin connectors