Step 1 | Removing old emblem or emblems can done neatly by using a heat gun on the lowest setting. Carefully pry the old emblem off using a putty scraper. |
Step 2 | Then clean the area where the emblem adhesive still remains. Use adhesive cleaner and a clean rag. |
Step 3 | Most important step is to use rubbing alcohol on a different rag to clean the remaining grease or dirt from the location. Allow it to air dry. |
Step 4 | Using a level or ruler to create a straight line parallel to the ground, marking the location of the emblem against desired surface or body lines. Use painter’s tape to make your guide lines. |
Step 5 | Prepare the emblem, making sure it's clean. Be sure to never touch the application adhesive on the back of the emblem after Remove the backing tape from the adhesive. |
Step 6 | Hold the emblem just above the surface in the desired location, using the painter’s tape as a guide to keep the emblem level located properly. |
Step 7 | Stick the emblem on and hold it in place until the adhesive has had a chance to setup bond on the surface of the vehicle. This usually takes 10 seconds..
|