material: metal
color yellow
Voltage: 6V
Speed: about 5mm/s
Bearing length: 45mm
Module supply voltage: 2V-10V
Signal input voltage: 1.8V-7V
Single working current: 1.5A
Peak current: 2.5A
Low standby current: less than 0.1uA
Product size: 11.8 * 1.7 * 0.8cm / 4.64 * 0.66 * 0.31in
feature:
All-in-one design, the top push rod will not slide out.
Built-in collinear circuit, if the input pin is left floating, the motor will not work
Built-in thermal protection circuit with hysteresis effect (TSD), no need to worry about motor stall.
Dual H-bridge motor drivers. It can drive two DC motors or one four-wire two-phase stepping motor.
Packing list:
1 * Electric cylinder pin
1 * Driver board
notes:
1. Try to balance the top of the putter. Can not withstand too much radial force.
2. In order to prevent the motor from being burned when it rotates, it is recommended to connect an external drive board or motor current limiter.