AJCMods 3D Printed Front Splitter & Aero Rear Winglets for the Arrma Vendetta Speed Run Car

 Custom made to fit perfectly around the stock body

**The Car & electronics shown for demonstration purposes only**

**this listing is for the Splitter & Winglets Only**

 Proven effective at reducing drag at high speed and shown to greatly improve high speed stability as a flat bottom creates over 1/3 of the car's downforce! This kit also helps reduce "parachuting drag" from the nature of an open cavity that these large RC  bodies have. The kit works to force air up and over the vehicle, as well as through the bottom, all while keeping air out of the inside of the car. MUST HAVE if attempting 100+ MPH passes

Includes all hardware for installation and installs in less than 15 minutes!