AJCMods 3D Printed +2" Bed Widening Kit for the TRX6 Flatbed Hauler!
Click Here for our Standard +1" Version
Great upgrade that adds a little over 1" on either side which allows you to haul actual 1/10 and 1/8 scale cars, trucks, and crawlers rather than just a few select cars that fit on the hauler in its stock form. This is an 8-piece set that bolts together and then slides right in place in between the stock bed and the stock railings. Great to pair with our dually kit and fender kit for the ultimate 10-wheel beast truck that can haul anything!
Instructions:
Assembly and install is fairly straightforward, but you will need to spend a good amount of time up front prepping the hauler for install. You must first cut all under-bed zip ties that secure the LED wire looms so the light wires can unwind and "stretch" the +1" on either side needed for the expansion. Some of these can be tricky to get to, we recommend using a Plato 170 or similar tool. Additionally, a zip tie that is towards the back of the main cub must be snipped, this can be accessed from underneath and is tucked up inside about 3" - it will be tricky to snip this last one! Once all zip ties are cut the install is quick and easy. First assemble the two sides together, being sure to follow the markings of each piece - D1, D2, D3, D4 for Drivers side, and P1, P2, P3, P4 for passenger side. These pieces bolt together using the (3) provided M3x25 screws for either side. Once you have two assemblies, remove and discard the side rail screws, insert each side in place, and reinstall the side rails using the provided extra long M3x50 Screws. During this process ensure that no LED wires are being pulled too tight. Once installed check to confirm all LEDs are working, install the provided zip-ties where needed, and you are good to go!
