Inboard Prop Puller For Ski / Wakeboard / Surf Propellers Works on 3/4" to 1-1/8" Shaft Replaces For Part #PULR-PT-POINT
Features:
1.Fitment: For Removing your Ski /Wakeboard / Surf Inboard Prop. Works on 3/4" to 1-1/8" shaft, Works great on tournament ski boats and other inboard with a 1-1/8" maximum shaft size. Clearance required between propeller hub and strut is 1/4"minimum.(NOTE: Must have dimple in end of shaft to use)
2.Replacement: Alternative to Part #PULR-PT-POINT in terms of function and performance.
3.Design: Jaw opens from maximum of 4.5" to 3.25". These tools have fine thread screws to enable a strong pulling force with little effort. Designed to remove 2, 3 and 4 blade propellers on inboard shafts.
4.Function: Remove even the most stubborn props easily with this industrial strength traditional style prop puller. Letyou enjoy your time on the water, instead of laying on the ground fighting witha stuck prop.
5.Superior Material: Made of high strength heat treated alloy steel and plated for rust protection for durability and strength, ensure long-term and reliable performance.
Fits For 3 or 4 Blade Prop
Designed to pull a 3 or 4 blade in board ski, wakeboard or surf propeller, this is a must-have tool to keep on board ifyou want to carry a spare prop.
Fits For 1“ and 1-1/8" Shaft
Fits 1“ and 1-1/8" shaft diameters,Works great on tournament ski boats and other inboard with a 1-1/8"maximum shaft size.
Easily Operation
The shaft taper make it extremely difficult to remove the prop when replacing it, but, with this tool, you can simply andquick loosen it, you won't take 15 minutes to do the whole job by following operation guidance.
JAW OPENS
The puller jaw opens from maximum of 3.25" to 4.5". This is a typical length fitment for most 1" or1-1/8" shaft diameter props.
DAMAGE AVOID
Designed an exclusive swiveling screw pointwhich could prevents damage to the ends of drive shafts, also it has fine thread screws to enable a strong pulling force with little effort.
Package included:
1 x Inboard Prop Puller