Contactless CDI ignition 12V/70W DC, suitable for all air-cooled Yamaha DT175, DT125MX and E

You can find many other parts and custom-made products in my "MikePowerParts" shop.

The ignition is based on the Ducati ignition system from the Minarelli AM6 engine.
It is very reliable and has proven itself on a 2800km tour from Germany to Croatia, crossing the Alps twice under the highest stress, without any problems. To date, the ignition is installed in my DT50 2M4 and has been running for over 15,000 km without maintenance and without any problems.
At 734g, the pole wheel is about half the weight of the original, which leads to improved response, but still does not lose any torque in the lower speed range.
Anyone who places particular value on a heavy flywheel can have it made by me on request.
Before dispatch, each ignition is carefully tested on an ignition test bench in all speed ranges between 500 and 13,000 rpm. Furthermore, all flywheels are finely balanced.
The ignition is roughly preset so that the engine can start immediately after installation. However, precise adjustment using a strobe light is advisable.
This is described in more detail in the supplied instructions.
The vehicle wiring harness must be adapted to the new ignition.

Connection to the vehicle electrical system is very simple, since only one cable supplies the entire vehicle electrical system, including the battery, with DC voltage.
Installing a battery is not absolutely necessary. A smoothing capacitor (available in the shop) can be used instead of the battery.
All the parts you need to convert to 12V, such as lamps, flasher relays, horns, batteries, cables and plugs can also be found here in the shop.

A puller (M26x1.5mm) and a flywheel holding tool are required for disassembly. You can also purchase these tools in the shop.
Experience has shown that you should use new spark plug connectors and candles.

Scope of delivery:
- Illustrated installation instructions
- Stator with base plate
- Screws for base plate
- Flywheel
- CDI with ignition cable
- Voltage/charge regulator

The installation must be carried out by a specialist company!