- 234-4355 234-4368
- Built to strict quality control standards
- Direct Plug-In Replacement
- 100% factory tested
- 1 year Warranty
- 4 wire configuration
- Brand new Oxygen sensor
- Tested before shipment
- For 2005 2006 2007 2008 2009 2010 Honda Odyssey 3.5L J35A6 1*Downstream Front & 1*Downstream Rear
- For 2005 2006 2007 2008 Acura RL 3.5L 1*Downstream Front & 1*Downstream Rear
- For 2005 2006 2007 2008 Honda Pilot 3.5L 1*Downstream Front & 1*Downstream Rear
- For 2006 2007 2008 Honda Ridgeline 3.5L 1*Downstream Front & 1*Downstream Rear
- For 2005 2006 2007 Honda Accord 3.0L Auto Trans 1*Downstream Front & 1*Downstream Rear
- For 2003 2004 2005 2006 Acura MDX 3.5L 1*Downstream Front & 1*Downstream Rear
- For 2004 2005 2006 Acura TL 3.2L Auto Trans 1*Downstream Front & 1*Downstream Rear
-
For 2003 2004 Honda Accord 3.0L Coupe Downstream Pair V6 3.0L Automatic Transmission
- 2pcs oxygen sensor
How to install the oxygen sensor?
Step 1 - Some sensors are equipped with a heat shield that must be removed before the sensor removal, this is performed by removing any mounting bolts.
Step 2 - By using a regular socket it minimizes potential damage to the sensor body and the threads, this technique helps avoid stripping the old sensor upon removal.
Step 3 - Then, locate and disconnect the wiring connector, this step should be done before removing the sensor if the wiring is still attached.
Step 4 - Its important that the wiring harness connectors are exactly the same, each sensor is unique to it's position and is located in the system by its connector configuration. (Note: some replacement sensors have a universal electrical connector that must be configured to the wiring of the old sensor.)
Step 5 - Use a small wire brush to help clean the threaded port to ensure a proper seal of the new sensor. Gently install the new oxygen sensor by hand while keeping the wiring and connector free from bends.
Step 6 - Gently tighten the sensor while keeping wiring free from damage, these sensors need to be fairly snug to avoid leakage.
Step 7 - Once the sensor is tightened, reinstall any heat shields or bracing that had to be removed.
Step 8 - After the heat shield has been reinstalled, mount the connector to it's holder and reattach the connector back onto the wiring harness. If the car has diagnostic trouble codes, they will need to be cleared.
The only way to know if the O2 sensor is functioning normally is to check its responsiveness to changes in the air/fuel mixture, by Voltage Measurement or Waveform Simulation.
Use a multimeter to contact the different color Wires. (Use back probe method, DO NOT pierce the wire.) For a good sensor, voltage should fluctuate constantly between 0.1 and 0.9 volts after starting the engine for 2 or 3 minutes.
