Harman 3-20-60906 Auger Feed Motor, 4 RPM (CW) | Aftermarket
This 4 RPM auger feed motor from Gleason Avery has a clockwise rotation (CW) as viewed from the shaft side. This motor is used ONLY used in direct drive applications where the motor is attached directly to the auger for the following models. Made in the USA and easy to install:
- Invincible Insert, Invincible T, Invincible RS
- Accentra Insert
- P35i, P35i-C
- P38, P38+, PP38++
- P43, P43-C
- P61, P61A, P61-C
- P68 - pre serial: 008280309
- PF100 Furnace - pre serial: 008350087
- Accentra52i , Accentra52i-TC
- Older feed motors dating prior to 2006 may use a feed/ auger motor that has a cooling fan on the back of the motor. Updated auger motors do not have this fan anymore as it is not required. Replacement fans for older auger motors is part # 3-20-08791
- Accentra-Cast, XXV and the Advance made before 2009 use an indirect chain-drive feed system and require a CCW spinning motor, part # 3-20-08752.
- Accentra FS, XXV and Advance made in 2009 and after have the redesigned UL feeder body and use auger motor part # 3-20-00677
- P68 pellet stoves (Pre serial # 008280309) used this motor. Current P68 units (After serial # 008280308) have a 6 RPM auger motor part # 3-20-09302
- This information is included in a 2008 Technical Update from Harman
Replacement For Part Number:
- 3-20-60906
Technical Specifications:
- 4 RPM, clockwise rotation, 120V AC 60Hz 0.72A, 3/8" diameter x 1 1/18" length, 2 female 1/4" terminals
Assembly Instructions for 3-20-60906 Auger Feed Motor:
- Unplug your stove
- If there are pellets in the hopper
- Gain access to the rear of the stove
- Locate the 7/16" motor set screw on the roller cam assembly and loosen it. Disconnect the wires from the motor to the wiring harness and pull on the auger motor. The motor will uninstall with the mounting frame attached to the motor, set this aside.
- The mounting frame will need to be transferred to the new motor, take a picture of the old motor with the mounting bracket attached for reference.
- Reinstall the the new feed motor with mounting bracket attached, connect to the auger shaft with the 7/16" set screw on the roller cam assembl
