Cleveland Iron Works combustion exhaust blower for PS60 and PS130 pellet stoves. Genuine OEM replacement part, fits perfectly and install easily.
Cleveland Iron Works Models:
Installation Instructions:
Unplug the power from the unit
Remove the side panel closest to the combustion blower.
Disconnect the 3 wires running to the motor (Pay special attention to the location of the yellow and green ground wire.)
Remove the 4 wing nuts holding the mounting plate in place.
Gently pull out the motor & scrape away any gasket material that may be left sticking to the housing.
Install the new motor. Make sure it seats tightly against the housing (Be careful not to damage the fan blade when setting the blower in place).
Reinstall the 4 wingnuts.
Reconnect the 3 wires to the blower (Make sure the yellow and green ground wire is connected to the proper spot on the motor).
Specifications
|
|
---|---|
Dimensions | |
L x W x H | |
Air Discharge | |
Blower, Motor & Bearing | |
Type | AC Shaded Pole |
Rotation | CW |
Blade Type | Metal |
Housing Material | Aluminum |
Bearing Type | Ball |
Outboard Bearing Type | N/A |
Bearing Lubrication | High Temp |
Motor Insulation | Class H |
Motor RPM | 3000 |
Motor Connection | Male spade terminals |
Variable Speed Compatible | Yes |
Airflow | |
CFM | 80 |
Installation | |
Mounting Type | Included Velcro, tape and noise reduction padding. Pre-installed. |
Electrical | |
Volts | 115 |
Motor Frequency | 60 Hz |
Watts | 53 |
Amperage | 0.55 |
Power Cord | Not included |
Power Cord Length | N/A |
Power Cord Type | N/A |
Accessories | |
Cross Support Brace | N/A |
Noise Reduction Padding & Velcro | N/A |
Other | |
Packaging Materials | Shipping box, bubble wrap, foam |
Compatibility | |
Cleveland Iron Works | PS60W, PS130W |
Documents | |
Installation Instructions | See above |
Video Library |