- Condition: 100% new
- Color: Black
- Material: Plastic
- Size: As picture shows
- Video Cable Length: approx. 600 cm(236.22 inch)
- Power Supply Cable Length: approx. 100 cm(39.37 inch)
- Camera Connection Type: Wired
- Placement on Vehicle: Rear, License Plate Area
- Image Sensor: 1/4inch CMOS PC7070
- Effective Pixels: 640 x 480
- Horizontal Resolution: 480 TVL
- Minimum Illumination: 0.01 Lux / F = 1.2
- Night Vision: Yes
- Field Angle: 170 degrees (diagonal), 138 degrees (H), 125 degrees (V)
- Synchronization: Internal synchronization
- Signal to noise ratio: >48db
- Signal System: NTSC
- Electronic Shutter: Auto
- Video Output: CVBS RCA interface, (1.0VP-P,70OHM)
- White Balance: Auto
- Backlight Compensation: Auto
- Power: DC 12V
- Operating Temperature: -20 C~ +75 C, RH95% Max
- Storage Temperature: -40 C ~ +80 C, RH95% Max
- Waterproof: IP67/IP68
- Item included:
1x Car Rear View Camera
1x 6m Camera Video Cable
1x 1m Power Cable
1x pcs Double Side Adhesive Tape
Compatible With: fit for Audi A3 A4 B7 A6 A8 Q5 Q7 A6L -
This Is Aftermarket Replacement Item But Not Genuine
- Note:
1) All dimensions are measured by hand, there may be small deviations.
2) Typically, most monitors supports both NTSC and PAL TV system. So it doesn't matter what the camera is PAL or NTSC system.However, if you are not sure, please check that your monitor supports NTSC or PAL system.
Product Dimension:
Feature:
1) According to the original factory specifications.
2) Support night vision.
3) 1/4inch CMOS PC7070 imaging sensor.
4) High-definition and wide viewing angle.
5) Guide line are included.
6) Waterproof and durable.
7) 6m Video cable.
8) Can help avoid incidents and accidents abrasion well.
Installation Guide:
1) Take out your stock license plate light at the back of your car.
2) Fix the camera to where the stock license plate light was.
3) Connect the built-in license plate light of the camera to where the stock license plate light was connected to get the power.
4) Connect the power of the camera to your reverse lights - red wire to positive and black wire to negative.
5) Connect the video cable of the camera to the extension cord.
6) Connect the extension cord to your car monitor.
7) You will see the images when your car is in reverse shift.
