This is the Compustar 1-Way

1WG7R-SP

1-Way G7 4-Button Remote Compustar 1WG7R-SP, 1-Way, 

Antenna ANT-1WSP, ANT-2WSP, 

FCC ID: VA5REC300-1WSP

 4 BUTTON Replacement Remote Control.

FCC ID #: FCCID VA5REC320-1WSP VA5REC3201WSP

  (on back of case)

Interchangeable Part #s:

RF-P1WG7-SP RFP1WG7-SP RF-P1WG7SP RFP1WG7SP

Model Number: 1WG7R-SP  Part#: IC: 7087A-1WREC320SP

IWREC320SP

1WG7R-SP

1WG7RSP IWG7R-SP

IWG7RSP

 Model Number:
NU800R 700R
Buttons: 4; Lock/Panic, Unlock, 

Trunk Opener, “*” Car Starter

Frequency: 433 MHz

 Compatible Antenna Number: 

ANT-1WSP, ANT-2WSP

Transmitting Frequency:

Is this a 1 Way Keyfob?: Yes

Is this a 2 Way keyfob?: No

Battery Type: CR2016 x 2

Keyfob Color: Black

LED Color: Blue

See Item Specifications for more details

Compatible With the following

 Aftermarket installed

security systems:

Compatible Control Modules:

• CM-900X
• CM-DC3
• CM-X
• CM2305-A
• CM2500
• CM7000-AS
• CM7200-S
• CM900-AS
• CM900-S
• CMBMXA0
• CMVWXA0
• SmartKey Starter® for Mercedes-Benz

Programming Instructions:

• All of your Compustar/Arctic Start Remotes - must program all
•  remotes during same programming sequence, otherwise, 
• all the remotes won't sync at the same time.
• Must be at the vehicle.

Important Note:
The engine will remain off for the entire process. Please keep your foot 

off of the brake pedal the entire time. Also, please make sure your doors are closed

 during this procedure.

During this remote programming process, you will be cycling the key in

 the ignition (without cranking/starting the engine) multiple times in order to 

cycle between the ignition on and ignition off positions. The ignition ON position,

 will be the last ignition slot before the engine start cranking over. And then turn 

the key all the way back like you are taking the key in and out of the ignition; this 

will be your ignition OFF position.

1. Do Not start the engine. Cycle key from ignition OFF to ignition ON 5 times within
2.  10 seconds. Key should be left in the ON position, should receive 1 parking light flash.
3. Tap LOCK on first remote, should receive 1 parking light flash; repeat step 2 for 
4. any additional remotes.
5. Wait 7 to 10 seconds for 2 parking light flashes to verify exiting programming.

Once the programming is complete, please test your remotes by checking if you can

 lock/unlock. If the remotes do not sync with the system, please re-attempt

 the remote programming.

If you are able to complete the remote programming sequence but the remotes do 

not program, then please locate the Compustar antenna. The antenna will be

 located behind the rear view mirror and attached to the windshield. Please 

disconnect the antenna cable for 1 minute then plug the cable back in 

and re-attempt the remote programming sequence.