FCC ID: ELVAT5C

 Interchangeable FCC IDs

 Interchangeable Part #s:

Interchangeable circuit board #

 Frequency: 302 - 309 MHz

 LED color: Red

 2 buttons

 Battery: (1) 23A

Compatible with the following systems:

APS100

APS150

APS150A

APS175

APS200

APS25KB

APS250

APS250A

APS25CLVED

APS300

APS300R

APS350

APS350A

APS15KB

APS40

APS25HJLA

Programming Instructions:

It is important to remember that during programming, each individual step of the procedure must be executed within 15 seconds of the previous step. When the 15 second time limit is allowed to expire, the system will automatically exit program mode. This is indicated by a long "chirp" from the siren.

Additionally, any time the ignition key is turned off while programming, the system will immediately exit program mode. This is also indicated by a long "chirp" from the siren.

To program additional transmitters:

1. Enter the vehicle, and turn the ignition key to the "on " position.

2. Flip the valet switch on - off - on - off - on - then off.

3. The dash LED will flash once, and the siren will "chirp" once, indicating the system is ready to accept programming for channel 1 or the arm/ disarm and panic functions.

4. You can assign any of the three transmitter button functions listed below to channel 1

a. Pressing button #1 on the keychain transmitter.

b. Pressing button #2 on the keychain transmitter.

c. Pressing both buttons simultaneously on the keychain transmitter.

5. Press and hold the selected choice a, b, or c above, until the siren emits a long "chirp" to confirm that programming of channel 1 was successful.

6. Move the valet/bypass switch on, then off again.

7. The dash mounted LED will flash 2 times, and the siren will "chirp" indicating that the system is ready to accept programming for channel 2, or the pulsed ground output for remote trunk release, remote car starter, etc.

8. You can assign any one of the two remaining button functions listed in 4a, 4b, or 4c above to operate channel 2. You cannot use the button(s) that operate channel 1, selected in step 5, to operate channel 2.

9. Press and hold the selected choice. The siren will emit a long "chirp" to confirm that programming of channel 2 was successful.

10. Move the valet/bypass switch on, then off again.

11. The dash mounted LED will flash 3 times, and the siren will "chirp" indicating that the system is ready to accept programming for channel 3. (APS 350)

12. Press and hold the remaining transmitter button function. The siren will emit a long "chirp" to confirm that programming of channel 3 was successful.

13. To exit program mode, either turn the ignition key to the off position, or move the valet switch on then off one additional time. This is indicated by one short chirp then one long "chirp" from the siren.

NOTE: If programming to a Keyless Entry (non alarm) unit, there will be NO chirp indication.

QUICK REFERENCE

You can program any individual channel, without reprogramming all channels, by following the quick reference chart below.

After the desired channel is programmed, turn the ignition key to the off position to exit programming mode.