GLOCK COPPER GUN GREASE:

The same Anti-friction, anti-seize, high temperature, water resistant, no run, copper grease found in a brand new Glock off the assembly line. When you buy a new Glock you are NOT suppose to clean off the copper grease, you are suppose to let it prevent wear over time by itself. This special Bronze Oilite grease serves two important purposes. First it works as a Anti-friction agent as you break  in your gun. Bronze Oilite is a much softer metal than steel and the polarized petroleum distillate is a lot thicker than basic gun grease, these two factors give more protection than standard gun grease for parts with steel on steel contact that take lots of abuse. The second reason Glock applies this is because when they make a new gun there is no way to know how long it may sit on the shelf before it is sold. This anti-seize grease is ideal for long term storage because will not run like typical gun grease or gun oil. This Bronze Oilite grease can also be used in place of regular gun grease or to pack in your internal springs and your magazine spring to keep moisture from rusting them up. Bronze Oilite can also be used in other firearms as well. Just a dab of this at a time because a little of this Nanotechnology Bronze Oilite grease goes a long way. Place a small drop on the rails and some other metal on metal contact areas or anywhere else you would use traditional gun grease

Glock treats the Nanotechnology* Bronze Oilite copper colored lubrication as a factory installed part of the pistol.

*Nanotechnology is the manipulation of matter on a near-atomic scale to produce new structures, materials and devices.

Anti-friction Copper Colored Bronze Oilite. Saves you money. No more wet and messy oils. LUBRICATION WILL NOT MIGRATE OR SPLASH EVEN UNDER FULL AUTOMATIC CONDITIONS OF THE GLOCK 18. Shipped with USPS first class. Original Lubrication found on Glock pistols assembled in Smyrna Georgia  >>> Contains Bronze Oilite ball bearings and is salt water proof. Will not attract dust or dirt.  As used on the original Glock 17 endurance test of 1 million rounds fired from a single pistol*. *Test conducted at the Santa Clara Gun Range. The Tested Glock 17 was purchased back by Glock for further testing.

IMPORTANT: DO NOT DILUTE. The bronze oilite ball bearings are designed to attach to the pores of the Steel and rotate freely in the Polarized petroleum distillate...● lubrication Syringe applicator PRE-LOADED with the Bronze Oilite

* 08-02-2010 | 12:44 PM

SJgunguy24

The old National Shooting Club in Santa Clara had a G 17 that had 1,000,000 rounds, and the factory took that for testing. My 17 is close to 50 thousand rounds.