30° tilted and STAND Raised by 30mm with rubber pads for your
UAD APOLLO x4
(not compatible with other devices!)
This STAND allow you to use your UAD APOLLO x4 sound card
on your desk more ergonomic layout
and it may affect about longer flow state when writing, listening, recording or editing music.
- It is
portable, easy to detach and attach again
- the 30mm Raise keeps the front connections accessible
- You can bring it to your live gig.
This system have 2 pieces,
just slip them from sides
and READY to use!
It will be tight enough to stand perfect on your desk without slip or wobble.
Installed Measurements with the UAD Apollo Twin X Duo/Quad:
This stand will tilt the sound card by 30 degrees, so the sound card faceplate will be tilted 45° relative to the table surface.
The overall height with the stand at the back: 154 mm (6.06 inches)
The overall height with the stand at the front: 56 mm (2.20 inches)
The footprint of the stand on the desk: 138 mm (5.43 inches)
Pros:
-
Very stable!
-
Really lightweight and strong enough.
-
There is no connecting rod at the rear
.
-
With this stand, you can handle your device as cohesive system without worrying about it falling apart.
-
It is
portable, easy to detach and attach again
-
You can bring it to your live gig - forget the heavy laptop stands and weird unstable things.
Cons:
Unfortunately Decksaver(tm) is not fully compatible with this stand.
MAIN FEATURE: It will be tight enough to stand perfect on your desk without slip or wobble.
-----------------------------------------
About st3nD tabletop stands:
All products are made with 3D printing, followed by some post-processing: deburring, sanding, surface cleaning.
The main goal
is to develop and manufacture high quality table
stand
s with the following features:
-
Easy
installation without glueing,screws or any tools.
-
Stable feel,
no sliping, free of wobbling.
-
Easy handle the stand and your device together as a
cohesive system
without worrying about falling apart when moving.
-
The system
don't take up more space sideways
like the device own.
-
Really
lightweight
and strong enough.
-
No middle rods or any stabilizers.
-
Portable
so you can bring it to your live gig easily.
These are the considerations I keep in mind when design and making stands.
I try to lower prices as low it possible for save your bucks but look
after the quality too. I manufacturing these products one by one. So
these handmade stands are different than mass products. This is the
reason why they are not so so cheap as I want it too. I will make the
stand for you, just for you, so you can focus using your device more
ergonomic.
IMPORTANT:
The device is only an illustration for the stand, which is not part of the sale.
Shipping is depend printing que, printing time, and your country distance and
shipping conditions.