This auction is for a complete set of
O-Rings for Inspiration Rebreathers.
These are new British Standard O-Rings,
direct from the manufacturer, and are the correct size (BS Number), hardness
(Shore) and material (Nitrile or Viton) for their specific use.
The complete set is £19.99 for 8 packs, these are listed below in the following table.
Updated in 2022 to include frequently
asked for O-Rings, and to remove those less used, overall there are more
O-Rings.
|
Pack |
Description |
|
ADV Kit |
7 O-Rings for the AP
Diving ADV, including the small hard O-Ring (90 shore), T Piece & Banjo
O-Rings for new and old ADV models |
|
Canister Kit -
Classic or Vision |
2 large O-Rings to
seal the Classic or Vision Canister / Scrubber, select your electrics on
checkout and I’ll send the right type. |
|
Flow Stop Kit |
7 O-Rings to service the flow Stop valve, includes a T Piece O-Ring |
|
GCS / Hose Kit /
Tank |
Selection of 9
O-Rings for a male and female GCS hose or Auto Air Hose and the tank valve |
|
Hose Kit |
13 O-Rings for
convoluted hoses includes an orings to seal the head/hose/cell holder |
|
Inflator Kit -
Diluent |
14 O-Rings for the
inflator/MAV for FMCL and BMCL, including the large soft (50 Shore) one,
depending on type you may have extra O-Rings available for hoses etc |
|
Inflator Kit -
Oxygen |
14 O-Rings for the
inflator/MAV for FMCL and BMCL, including the large soft (50 Shore) one,
depending on type you may have extra O-Rings available for hoses etc |
|
Mouth Piece Kit /
OCB |
16 O-Rings for
mouthpiece, hose ends and OCB |
When
checking out, please select the type of Electronics you have on your unit, that
way you’ll get the correct O-Rings for your canister/scrubber
Please see
my other auctions for other diving related O-Rings.
Note - All O rings and new and are
direct from the manufacturer. Orings in the picture show the full set. Viton O
rings are black...it costs more to have them coloured!. O rings are contained
in a sealed bags with a label indicating the contents. Orders are sent in an
padded jiffy bag. Only competent persons with appropriate training should
service diving equipment, these O-Rings are offered as spares to
replace/maintain rebreathers and regulators. O-Rings should be replaced in
accordance with the manufactures instructions, applying appropriate lubricant
(where applicable), ensuring the O-Ring is seated properly and cleaned as appropriate.
No responsibility is accepted for their use or misuse. Please ensure you
perform a positive and negative check of the rebreather loop before diving
along with other checks advised by the manufacturer.