-Saitek/Logitech Throttle Quadrant NOT INCLUDED
-Parts are 3D Printed
-Product Is Tested Before Shipment
This is V2 of my Flap Detent Kit for the Saitek/Logitech Throttle Quadrant. V2 adds the inclusion of a locking pin that aids in securing the removable detent as well as the introduction of the 737 detent option. If you have already purchased V1 with the GA detent only and want to upgrade to V2 for the 737 detent, please send me a message and I will give you a discount. (please note, you will have to purchase with the same eBay account as you purchased V1 to get the discount)
Included in the Flap Detent Kit for Saitek/Logitech Throttle Quadrant.
- 2 Detent Holding Clips
- 1 Spring Loaded Sliding Detent
- 1-2 Detent(s)
- 1 Locking Pin
- Installation Manual
Installation
The two Detent Holding Clips are attached with the included foam sticky tape to the throttle quadrant. After the clips have been attached the detent can be clipped on and off of the throttle quadrant to allow the axis to be manipulated with no detent or to swap to a different detent. The Sliding Detent is slid over the handle shaft and then secured in place by the factory handle end.
To Utilize In MSFS
Go to Options-ControlsOptions-SaitekProFlightQuadrant-FlightControlSurfaces-SecondaryControlSurfaces and bind the Flap Axis to the axis with the detent attached.
-The GA detent has been tested on GA aircraft in Microsoft Flight Simulator that are equipped with 3 flap settings. For example the Cessna 172 with flap Settings 10-20-30 degrees. It utilizes the factory detent built into the Throttle Quadrant for the last detent. The aftermarket detents are an almost identical strength to the factory detent when the lever is at the bottom of its travel. Any of the factory handle options (Throttle, Mixture, Prop) are compatible with the aftermarket detent.
-The 737 detent has been tested on all variants of the PMDG 737 in Microsoft Flight Simulator.