|
Continuously Variable Reversible
Intelligent Rain Sensor
Thermostat & UV Protection
Bidirectional Reversible Airflow
Quieter working with low noise
High Quality Brushless Motor
Automatic Remote Control
Install roof thickness:1 inch to 6-1/2 inch.
Opening size: 14 inch x 14 inch
|
|
|
---|---|---|
INTELLIGENT RAIN SENSOR AND THERMOSTATIntelligent rain sensor and thermostat to automatically control and regulate the interior environment. |
UV PROTECTIONThe RV fan is UV resistant, 3+ years, and it has CSA certification. |
CONTINUOUSLY VARIABLEBidirectional ventilation, single-end suspension structure, using DC motor + deceleration mechanism + transmission system, wind speed infinitely adjustable speed control, adjust the size or direction of the air volume, so that people feel more comfortable environment. |
Fan Blade: | 10 |
CFM: | 1000 |
Power: | 30W |
Voltage: | DC 9-16V |
Speeds: | continuously variable |
Mounting Type: | Ceiling Mount |
Noise: | below 70dB |
Lid Opening: | Auto + Manual |
Control: | Remote and Manual |
Install roof thickness: | 1 inch to 6-1/2 inch. |
INSTALLATION STEPS:
Step1: please remove the old existing roof vent and all old roof sealant for a minimum of 2"entirely around the roof opening.
Step2: Prior to installing the fan into the roof opening,apply a continuous strip of BUTYL tape or equivalent to the underside of the flange,making sure to cover the screw holes.
Step3: Using the insulated 16 gauge electrical connectors provided, connect the vehicle's 12volt power to the two fan power wires located on the driver side of the fan.
Step4: Insert the fan into the opening with the lid hinge facing the front of the vehicle and centering the fan in the opening. Make sure the power wires
slide to the interior and do not become entangled.
Step5: After the fan has been installed, remove the excess BUTYL caulk that may have squeezed out. Using a sealer apply a daub over every exposed screw head.
Step6: The interior Garnish Trim Ring must be trimmed to fit your particular RV roof thickness.
Step7: Complete the installation by placing any excess wiring to the inside of the roof opening and sliding the Garnish Ring into position.