Easy to use, REMOVABLE, Valentine1 v2 radar detector mount for Tesl;a Model3 and Model Y

If you, sometimes, leave your car in questionable neighborhoods and worry about
leaving your radar in the car, or sick and tired of the original suction cup mount
falling of the windshield, then Gof Mount is for you.

This is all it takes to install: 
  • This mount will hold the radar detector rigidly attached to the center screen.
  • It will not shake on bumpy roads and won't come off while doing spirited driving.
  • The mount addresses all the issues of the OEM suction cups that attach it to the glass.
  • There is nothing to glue to the center console or the radar detector. Everything slides and/or clicks-in.
  • It will not leave any sticky residue.

Here is how it behaves in a Tesla Model 3 while driving on an bumpy unpaved road:

This mount reuses the original suction cups
that originally came with the radar, they are only used for support.
The weight of the radar will compress the suction cups, rather then pull on them. 

Ships as 3, separate, 3d-printed pieces as shown on the photos. They are printed from a tough, high-temperature ASA material, that will
easily hold up to summer heat (tested from -15F to +125F) and is also UV resistant (Will not deteriorate over time). 

Assembly instructions:
  1. Slide the suction cup holder into position.
  2. Remove the original suction cups from the original radar mount.(as shown)
  3. Insert the suction cups into the suction cup holder with the small notch facing the special recess.
  4. Slide the radar clip on the Radar
  5. Slide the radar into the screen clip. 
  6. Slide the Mount on the radar clip

Assembly Instructions

NOTE: The mount does not work as well over glass screen protectors as they add considerable thickness to the screen.