International customers, please scroll down.

ONE.precision Carbon Bodenplatte für die Parrot AR Drone 2.0

Die Originalbodenplatte besteht nur aus einer dünnen, selbstklebenden Folie. Diese bietet kaum Schutz und ist zudem nicht wirklich passgenau gefertigt.Diese Folie kann problemlos wie ein Aufkleber abgezogen werden (haftet nur am Rand rundum)Nun kann die Carbonbodenplatte eingesetzt werden. Hierfür kann man entweder doppelseitige Klebestreifen (fragen Sie mich danach) oder aber ein handelsüblicher Klebstoff verwendet werden. Hier haben wir UHU Alleskleber getestet und für gut befunden. Die Platte kann bei beiden Methoden wieder abgezogen werden, und die Original Bodenplatte wieder angebracht werden, sollte dies aus irgendwelchen Gründen erforderlich sein.Der ganze Umbau dauert keine 5 Minuten.

Alternativ zum Alleskleber, bieten wir nun auch speziell zugeschnittene Klebefilme an, schauen Sie hierzu bitte in unseren Shop.

Das rechteckige Fenster in der Originalplatte wird nur beim Hersteller benötigt und macht bei der Carbonplatte deshalb keinen Sinn.
Das Fenster für die Status LED ist bei unserem Produkt ebenfalls verschlossen, so dass kein Schmutz eindringen kann aber man die Status LED trotzdem sehen kann.Die Carbon Bodenplatten passen exakter als die originale!Die abgebildete AR Drone 2.0 dient nur zur Veranschaulichung und ist nicht Teil dieses Angebotes.

100% made in Germany


English:
ONE.precision Carbon base plate for the Parrot AR Drone 2.0 

The original base plate consists of only a thin, self-adhesive foil. This offers little protection and is also not really made ​​a perfect fit. This film can easily be pulled off like a sticker (only liable on the edge all around) Now, the carbon bottom plate can be used. For this you can either use double-sided tape or a commercially available glue. Here we have tested UHU All Purpose adhesive and approve that.

As an alternative to the all-purpose adhesive, we now offer tailored adhesive films, please see this in our shop.

The plate can be removed again by both methods, and the original base plate should be re-installed, it may be necessary for any reason. The entire conversion takes less than 5 minutes. The carbon tiles fit exactly as the original! The pictured AR Drone 2.0 is illustrative only and is not part of this offer.

The rectangular window in the original plate is required only from the manufacturer and therefore does not make sense at the carbon plate.
The window for the status LED is sealed in our product, too, so that dirt does not penetrate but can you can see the status LED anyway.

100% made in Germany