Kit Includes:

• VW Facia Panel Adaptor
• VW Wiring Harness & Aerial Adaptor Lead

Compatible with following vehicles:

Car Make / Model	Year	Remarks
Volkswagen Golf	2003 - 2013
Volkswagen Passat	2005 - 2015
Volkswagen Polo	2009 - 2014
Volkswagen EOS	2006 - 2016
Volkswagen Touran	2006 - 2010
Volkswagen Caddy	2003 - 2010
Volkswagen Jetta	2005 - 2011
Volkswagen Scirocco	2006 - 2010
Volkswagen Vento	2010 - 2019
Skoda Superb	2008 - 2013
Skoda Fabia	2007 - 2014

Note: To use as a double din fascia the middle bar needs to be cut.

For Polo the dashboard should look like this

Please Note: You will need to connect the red wire to the ignition supply in the fuse box.

Fascia Adaptor: This adaptor will convert the non din-sized aperture left after removing the factory stereo to a single din size ready for head unit installation. The high quality finish, colour and texture are designed specifically to maintain the original look of your vehicles interior.

Wiring Harness: The wiring harness will allow to install the stereo.

There is an Aerial Adaptor also included with the Wiring Adaptor.

Please Note

• Red wire has to be connected to a separate ignition feed in the vehicle to make aftermarket head unit to power up
• Orange cable requires connection to illumination wire but only if the radio requires this for dimming purposes at night.
• Blue wire needs to be connected to the Remote Antenna or ignition supply wire (if rem ant wire not available) on back of car stereo.

Please Note:

• When connected your new stereo may not power up, and this is no fault of the wiring harness purchased.
• Audi / VW / Skoda / Fiat and other vehicles tend not to have an ignition switched live feed.
• In these cases it is necessary to manually connect a spurred live feed from fuse box for example to feed switched power so the new stereo turns on and off with the key.
• The wire in particular on the new wiring harness will be the red wire.
  

Aerial Adaptor: An Aerial Adaptor is needed when replacing the original factory fitted head unit with an aftermarket head unit.
The blue wire is connected to the back of the car stereo where there is a blue wire thats says antenna remote out or ant remote out.

TECHNICAL NOTE:

• CAR AUDIO FITTING ACCESSORIES ARE SOLD WITH LIMITED INSTRUCTIONS. 
• SOME KNOWLEDGE OF CAR AUDIO INSTALLATION IS HELPFUL IN CASE A MODIFICATION IN SOME RARE CASES MAY BE NECESSARY OR NEEDED.

IMPORTANT NOTE: Please make sure that is the correct  Fitting Kit for your car by firstly checking to see if your make, model  and year of car is listed in the advert. Secondly by checking to see if  the connection in the picture listed is the same as you have in your  vehicle.