Adjustable Holder Support Mount Fit For 50-80mm CO2 Laser Tube Engraving Machine
  • Condition: 100% new
  • Color:Grey & Black
  • Material: ABS Plastic & Rubber & Metal
  • Size: approx.11.7x6.7cm(4.61x2.64inch)(LxW)
  • Height: approx.10-16.5cm(3.94-6.50inch)
  • Item included: 1 x CO2 Laser Tube Holder
  • Compatible With: fit for Dia. 50-80mm Laser Tube

    This Is Aftermarket Replacement Item But Not Genuine

  • Note:

    1) All dimensions are measured by hand, there may be small deviations.

    2) Color may vary slightly due to the color setting of each individual monitor.

    Product Dimension:

    Feature:

    1) Using special plastic, the material is not aging, the laser tube can be fixed firmly, and the optical path is not easy to be biased.

    2) Adjustable diameter, suitable for 50-80mm diameter laser tube

    3) Liftable spiral, easy to adjust height

    4) Easy installation

    Usage:

    1) At the bottom of the tube support (four oblong holes), install four screws, fixed the holder on a flat surface

    2) Put the laser tube, adjust the height of tube holder to make the height of the laser tube appropriate, and make it and the reflector mirror (which near to light outlet of laser tube )at about 45 degrees

    3) Fastening all screws of tube holder


    DataCaciques