Car Rear View Reverse Camera Trunk Handle Fit for Audi A3 A4 A5 A6 A8 A6L A8L Avant
  • Condition: 100% new
  • Color: Black
  • Material: Plastic
  • Size: As picture shows
  • Video cable length: approx. 600 cm(236.22 inch)
  • Power supply cable length: approx. 100 cm(39.37 inch)
  • Camera Connection Type: Wired
  • Placement on Vehicle: Rear, Trunk Handle
  • Image Sensor: 1/3 "OV Color CCD
  • Pixels: 780(H)X580(V)
  • Horizontal Resolution: 480 TVL
  • Minimum Illumination: 1.0Lux F=1.2 (0Lux with IR on)
  • Night Vision: 5-10meters
  • Diagonal Viewing Angle: 170 degree optional
  • Synchronization: Internal synchronization
  • Signal to noise ratio: >48db
  • Signal System: NTSC
  • Electronic Shutter: Auto
  • Video Output: RCA interface, 1.0Vp-p, 75Ohm
  • White Balance: Auto
  • Backlight Compensation: Auto
  • Current Consumption: 50-60mA, Max 130mA with IR on
  • Operating Temperature: -20 C~ +60 C, RH95% Max
  • Storage Temperature: -30 C ~ +80 C, RH95% Max
  • Waterproof: IP68
  • Item included:

    1x Car Rear View Camera

    1x 6m Camera Video Cable

    1x 1m Power Cable

    1x User Manual

    Compatible With:(For the reference) fit for Audi A3 A4 A5 A6 A8 A6L A8L Avant

  • This Is Aftermarket Replacement Item But Not Genuine

  • Note:

    1) All dimensions are measured by hand, there may be small deviations.

    2) Color may vary slightly due to the color setting of each individual monitor.

    Feature:

    1) According to the original factory specifications.

    2) Support night vision.

    3) CCD imaging sensor.

    4) High-definition and wide viewing angle.

    5) Unique Design,With reference line functions.

    6) Easy to install, you can install the monitor via mount holder or universal bracket.

    7) 6m Video cable.

    8) Can help avoid incidents and accidents abrasion well.

    Install Tips:

    1) Take out your trunk handle at the back of your car.

    2) Fix the camera to where the trunk handle was.

    3) Connect the built-in trunk handle of the camera to where the stock trunk handle was connected to get the power.

    4) Connect the power of the camera to your reverse lights - red wire to positive and black wire to negative.

    5) Connect the video cable of the camera to the extension cord.

    6) Connect the extension cord to your car monitor.

    7) You will see the images when your car is in reverse shift.

    DataCaciques