Works with a system that already has a 120 volt pump and 120 volt ozone

If you are replacing an existing Balboa pak the following topside control part numbers are compatible and will work with this pak: VL200 (55123), VL240 (55080), VL260 (55081), VL401 (54665), VL403 (54664)

Power requirements: 240 volt or 120 volt 60 HZ, 30 amp, Class A GFCI-protected service (Circuit Breaker rating= 40 amp max)

Features

Awesome easy to fit in those tight areas under spas.

Most flexible plumbing install on the market today.

Readily compatible with domestic 120 volt or 240 volt input voltages for ease of installation.

Can easily be converted to 120 volt or 240 volt as required with jumper wire and dip switch bank control included.

Manufacturer presentation

Next Generation of Entry Level Hot Tub Control Systems

The Value Series (VS) family of hot tub control systems were designed using Balboa’s patented M7 temperature and flow sensor technology and a new universal control platform. These features increase the reliability, ease of installation and serviceability of the control.

Designed for Easy Installation and Service

The VS family is based on a common universal control platform, which increases feature flexibility while reducing installation and configuration problems. The VS family has exceptionally good feature flexibilities, so its performance is competitive with much higher-end products. The units incorporate Balboa’s patented M7 temperature probe technology, which eliminates the more failure prone pressure switches and simplifies the installation process by not having to drill additional holes in the spa.

Flexible, High Reliability, Feature Rich

The systems have a plastic enclosure to eliminate water intrusion. Connectors are built on to the circuit board minimizing wires and simplifying service. The different models have controls for a single two-speed pump or an additional blower or pump. All models featurea convertible power supply that can be wired for 120 or 240 volts, a 1.0, 1.5, 4.0, or 5.5 Kw heater and support mini, duplex or standard digital panels.

registered trademark of Balboa Water Group®

------------------------------------------------------------------

This Ebay item is for one:

Balboa WG® VS100 PCB, for VS100 PN# G4111

Electrical input:  120/240V 30A max 50-60Hz (required 40A GFCI)

Please note that the pump and ozone generator, must be on the same voltage.