2 top quality 12 volt cool white 1141 light bulbs. These have 13 large hi-output LEDs each and are direct replacements for standard 1141 & 1156 light bulbs. The last photo is an 1141 20 watt incandescent bulb for comparison. Super bright light, low current draw, low heat & super long life makes these a great choice.

product description:
This product is a new type of green light source for vehicles, which has passed the RDW E4 standard certification. The whole lamp is pollution-free, no noise, no electricity
Sub-interference, due to the use of German advanced constant current control technology, uniform light emission, full light color, and lasting constant.
Product parameters:
Working voltage: 12VDC
Color temperature range: 6000K-7000K
Luminous color: white light
Peak luminous angle: 360°

Features:
1. Good sealing: waterproof, high temperature resistance, corrosion resistance;
2. High brightness: 10000-12000MCD;
3. Energy saving: 5W is equivalent to the brightness of 40W tungsten lamp;
4. Safety: 12V safety voltage, double insulation;
5. Longevity: The service life of the light source is 50,000 to 100,000 hours;
6. Simple installation: just replace the original car bulb directly.
7. It can be used as front and rear fog lights/brake lights/reversing lights/turn lights, etc.
8. The model is the same as the original car, no need to change the line, just replace the original car bulb.
9. There is no delay in lighting, and the response time is fast. Without filament structure, the vehicle control circuit is not easy to oxidize.
10. Low energy consumption, high brightness, higher cost performance.
11. Rich in color and pure color, DIY can be done at will, highlighting personalized lighting.
12. Cold light source, good comfort, belongs to the green environmental protection light source.

LED has the following characteristics and advantages:
1. Simple installation, plug and play, no need to change the line,
2.Energy saving, low power consumption, high luminous efficiency, low load current, now the oil is too expensive, 10% of the fuel consumption is used in car bulbs, switching to LED lights can effectively save fuel consumption and protect the car circuit.
3. Low fever, more conducive to driving safety.
4. The corresponding time is fast. The traditional light bulb needs to be warmed up and emits light. There is a 0.3 second delay. It can travel a distance of 4.4 meters at a speed of 40KM/hour and 0.4 seconds. LED lights, no delay. It can effectively prevent rear-end collisions. .
5.Strong shock resistance, no glass, tungsten wire structure.
6. Long service life
7. Pure color, bright color, high brightness

Installation Precautions:
The original car glass lamp is very hot. Please be careful when replacing it. The LED has positive and negative poles.

Install Caution：
1. As a safety precaution, make sure that the car has had time to cool down properly before starting the installation process.
2. Put the vehicle into park or make sure it is securely in gear.
3. Be sure to turn off the ignition and remove the key.
4. Be careful to avoid burns, especially when turning on or off the vehicles lighting.
5. Be careful to avoid crushing or cutting the bulbs. Also make sure to not touch the bulbs with your fingers, as this will cause blotting.
6. Fully examine the connection of the contact points, ports and the wires as faulty connections can cause lighting problems.
7. Make certain that the end of the bulb does not come in contact with the interior light shield of the headlight when adjusting the bulb.