Need a light for your DIY project? Do not worry about LEDs and calculating the right voltage and current. We did it for you. This LED controller may provide the right power for four LEDs. Also, you can make a chain of controllers because the board has pass-through input ports. 

Features:

• Working voltage: 4 - 15 volts
• Output voltage: 2.95V. It's ideal for powering the decorative LEDs with the current limit of 20mA
• Pass-through input ports. You can make a chain out of your controllers if you need more LEDs. They have two power ports each and can be used to extend the supply voltage to the next controller
• Short circuit protection. Yes, the output is protected. Don't worry about possible shorts. It will not damage your project
• Pre-soldered JST PH connectors that allow you to attach and detach the LEDs easily
• Low power consumption
  
• 10 ports to connect the LEDs

Kit includes:

• Controller
• 11 LEDs wired Litz with a JST HP F connector
• One power wire with a JST XH connector

We recommend using this LED controller with our