3 Way Bilge Pump Rocker Switch & Alarm Panel AUTO-OFF-MAN Circuit Breaker Boat Marine
  • Condition: 100% new
  • Color: As pictures show
  • Material: Plastic
  • Size: As pictures show
  • Placement on vehicle: Center
  • Item included:

    1 x panel switch

    4 x screws

    1 x user manual

  • Suitable for: Boat Marine

  • This Is Aftermarket Replacement Item But Not Genuine

  • Note:

    1) All dimensions are measured by hand, there may be small deviations.

    2) Color may vary slightly due to the color setting of each individual monitor.

    Product Dimension:

    Feature:

    1) According to the original factory specifications.

    2) Modern design bilge pump panel with visual and audible alarm. (85dB Siren)

    3) Activates alarms and starts pump automatically when water reaches 2nd (high) float switch.

    4) IP66 C-7 Sealed Switch and water-resistant Siren.

    5) Backlight label module allowing easy recognition in darkness.

    Connect the wires as follows:

    1) Connect the Green wire to one side of the low float switch; connect the other side to the pump positive (+) terminal.

    2) Connect the Brown wire to the pump positive (+) terminal.

    3) Connect the Blue wire to the pump negative (-) terminal.

    4) Connect the Yellow wire to one end of the 2nd (high) float switch and the White wire to the other end of the high float switch.

    5) Connect the positive wire (Red) to the DC power source (the batteries) and the negative feed wire (Black) to DC negative (battery or bus bars).

    6) Mount the switch panel with the included self-tapping screws.

    7) Reconnect all the AC & DC powers. Turn on and off all branch circuits to check if the panel works normally:

    8) When the switch is in Manual position (MAN), the MAN lens on switch will illuminate, indicating the pump is running. The pump will run no matter if there is water or not (please use with caution).

    9) When the switch is in AUTO position, the AUTO lens on switch will illuminate; if the water level rises higher than the low float switch, the pump will run automatically and the MAN lens will illuminate.

    10) If water rises to the 2nd (high) float switch (when the low float switch fails, or the switch is left in OFF position), the pump will start automatically with the alarm light illuminating and the siren sounding.

    DataCaciques