Feature
-It is ideal for your electronics work.
-This is a excellent cordless soldering iron.
-4 in 1 design, convenient for use and easy to carry.
-Refill gas on the top of this product and tweak this button to OFF when refilling.
-It's suitable for using in welding, electronics maintenance, vehicle repairing, etc.

Specification
Material: Plastic + Aluminum
Gas Capacity: 12ml
Flame Temperature: 1300°C
Ironing Temperature: 450°C
Application: this product is suitable for maintenance of electronic hobbyists
Use fuel: butane (gas) and household lighter gas are common

How to use
1)Put the iron head
2)Push the switch to the ON position and hear the sound of 'click'.
3)Use an igniter or lighter, near the joint ignition.
4)Burn for 3 minutes after ignition and wait for the fire to extinguish. The iron head will continue to heat up.
5)Adjust the size of the flame, to the 'ten' direction is large, to the 'one' direction is small.
6)this product temperature up to 1300 degrees (iron temperature 450 degrees), the use of safety should be taken, after the use of the switch closed to the OFF position.
7)When using the gas soldering iron, pay special attention to wait until the flame is completely eliminated. When the object inside the soldering iron turns red, operate it again. The size of the flame should not be large to prolong the service life of the soldering iron.
8)The length of the flame is about 1.2-2.2 cm.

How to fill gas
1, Fill the gas with high quality gas and confirm that the switch is at OFF, then add it.
2, The gas tank can be imported into the air hole and compressed under the pressure.
3, About 10 seconds, filling gas could be completed. Wait a few minutes, let the gas stable, and then use.
4, if the gas is filled, the tail has a "hissing" sound, press the tip of the pen slightly into the air hole, it can be eliminated.

Note
1)The product is not filled with gas yet, please refill it before use.
2)Hot air head high, keep away from children.
3)Keep the flame away from your face, body, and clothes.
4)Avoid direct sunlight or storage above 40 degrees.
5)After use, make sure the flame size switch is off and the flame is out.
6)When filling the gas, the inlet is upward.
7)Once the solder head is removed, it can be turned into hot air head.

Package include
1x Gas Iron Tool