This kit includes an additional 10 dies to use with any bead roller with a 7/8 inch (22mm) shaft. With these additional dies on your bead roller you can create hemmed edges, offset flanges, contours, deep channels, and style lines. This kit also includes a polyurethane lower "skate board" wheel, which can be used with a variety of upper dies. The dies includes in this kit are inside and outside offset dies, 3/8 and 1/2 inch tipping dies, round and knife edge tipping dies, 180 degree lower die, lower edge forming die and a lower forming die. All are made of CR12 steel with a Rockwell hardness of 40-45 HRC.

• Fits most bead rollers with  22mm shafts

• Includes 9 steel dies and 1 polyurethane lower wheel

• Hem edges, create offsets and flanges, form style lines, contours and channels

• Kit includes the following:

  Polyurethane Lower Wheel,

  180 degree lower die

  Inside offset die

  Outside offset die

  Knife edge tipping die

  Lower edge forming die

  3/8 in tipping die

  1/2 in tipping die

  Round tipping die

  Lower forming die

• Packing Dimension(cm):21X21X9 

• N.W./G.W.(kg):3.5/3.7