HAND MADE HIGH CARBON STEEL IRISH SWORD
HANDLE IS MADE OF PLASTIC WITH STEEL WIRE WRAP & BRASS CLIP & POMMEL AND TOP OF THE KNIFE


LEATHER SHEETS ARE VERY GOOD QUALITY AND OF THICK LEATHER 

SIZE& MEASUREMENT:-

  SWORD OVERALL 40.00''

  BLADE LENGTH 32.00''

  HANDLE LENGTH 8.00''


If you are not satisfied with our service please contact us before leaving any negative or natural feedback.  We will resolve all issues as quickly as possible.



Disclaimer:
We are not responsible for any injuries associated with the use of our tools.  Our products are intended for legal use only by responsible buyers.  Therefore, we will not sell our products to anyone under the age of 18.
Before bidding please check your country laws as some countries Custom don't allow this.
If your purchase is held by Custom Authorities in your country/State we will
 not be responsible for that and no refund will be issued



Payment Method:
As Per eBay Policy



Shipping :
Buyers other than  USA & CANADA   please contact us to know precise shipping cost.  We offer a 25%shipping discount for two items purchased and a 40% shipping discount for three or more items purchased. 
We whip within 24 hours after receiving complete payment but this can be delayed due to weekends or Governments and Religious Festivals.
Due to region regulations we are not able to ship to Israel, Russia Federation
.  This is beyond our control and we apologize for this inconvenience.


Shipping Service:
We Normally use DHL & EMS & FEDEX



PRECAUTIONS:
 Our Tools are very sharp so open and use them very carefully We are not responsible for any injuries associated with the use of our tools


Tips to Care knife:

1.  NEVER STORE YOUR KNIFE FOR LONG TIME IN LEATHER SHEATH.
2.  LEATHER CAN ABSORB WATER, WHICH WILL RUST THE KNIFE.
3.  ALWAYS CLEAN THE BLADE AFTER USING WITH OIL OR WAX



                                                                     






You will receive same knife as shown in picture



    SAAD KNIVES 
(Manufactures and Exporters All Kinds Of Knives)





QUALITY STANDARDS
 Our Damascus blades are made from high quality non-stainless steels which rival or exceed any Damascus blade made from the 10 series with 15N20. Our Damascus combination has taken years to perfect and has been tested under a variety of application which will offer professional performance in categories of toughness, strength (lateral stress) and edge honing and holding ability. In a 5 spot Rockwell test our blades will average near or close to 58 which offers a perfect balances between its toughness and strength. Our blades due to carbon content need to be regularly treated with wax and/or 3 in 1 oil to maintain its superior quality.  


Questions
if you have any question feel free to send us message we aim to answer all questions within 12 hours

Feedback
                                                                   THANK YOU VERY MUCH FOR TAKING INTEREST IN OUR PRODUCTS