☆ Item condition: New

100% genuine products have been released in Japan.

If you have any questions about the details, please contact us.

[Appeared as a completed model with the same longing] 

Introduced in 1985 as Tamiya's first shaft 4WD racing buggy. A combative form with a low center of gravity design and high-performance running full of innovative mechanics immediately captivated many fans A reprint of the hot shot that was made is also available in the completed model. Based on the design concept that the form and structure are not touched as much as possible, only the updated reprint hot shot (2007), the chassis and form are the same at that time ¡You can easily challenge the longing of that time and the running.

[Enjoy running comparison of 4WD buggy] 

Shaft drive 4WD, front and rear double wishbone suspension equipped with adjustable type monoshock damper, etc. The main mechanism remains the same, but the front and rear drive shafts and propeller shafts are highly reliable dog bone type The oil damper is now the mainstream diaphragm type. Also, since it is equipped with ESC, the rear aluminum heat sink is not originally required, but this part, which is also the point of the rear view of hot shots, is equipped as a dummy. The completed chassis is already equipped with an RC mechanism, and it also comes with a wheel trigger type transmitter suitable for maneuvering the car, a driving battery and a dedicated charger, and you can charge the battery out of the box. You can run immediately. I'm looking forward to comparing it with modern 4WD buggies.

[Basic specifications] ● Overall length 390mm ● Overall width 235mm ● Overall height 150mm ● Body weight approx. 1270g ● Tread = 194mm (both front and rear) ● Tire width / diameter = F28 / 82mm R34 / 82mm ● Frame = ABS resin monocock ● Drive system = shaft Drive 4WD ● Diff gear = front and rear 3 bevels ● Steering = 2-split tie rod type ● Suspension = 4-wheel double wishbone ● Gear ratio: 10.04: 1 ● With 540 type motor ● Tamiya TEU-101BK With speed controller * Power supply for transmitter (single) 4 type 3 batteries) are sold separately.

[Uses 2.4G radio that can be easily played with multiple units] 

In addition to the painted body and finished body, a wheel trigger type transmitter that is ideal for car control, a 7.2V battery for running, and a charger are also set.The RC mechanism uses a 2.4GHz radio set that can be easily enjoyed by multiple units without the need for band adjustment such as crystal replacement. 2.4GHz, which is also used for computer wireless LAN, has a one-to-one correspondence between the transmitter and receiver (vehicle body), so there is no concern about interference, and the transmitter and receiver have already been paired. There is no need for troublesome setup work. In addition, the transmitter uses a grip cover and a trigger cover. It can be adjusted by attaching and detaching, and it is a structure that is easy to operate even with small hands.