the
Cross# PUS15 20-5 W-V Not original OEM Please see the short Vid for how to wire
This is a replacement and not the original OEM made by control-4 -
This power supply has more Watts, unlike the normal one this one can provide up to 25% more For most normal users this is overshooting and you can buy the normal one we listed however if you are heavy user this is the one for you
Simple installation but includes cutting the wire and connecting it to the new PSB
For repairs by replacing of dead PSB in matrix switches
If your unit is dead or if you know that your power board is defective, you will need to upgrade to the new expensive matrix switches >$1000
but if you are short, you can replace the power supply at your matrix and most probably get a few more years of service be advice that this PS will provide power as needed but it is not identical to the one that failed on you.
installation will take 30-45 min and include disconnecting the defective PS and installing the replacement including connecting the power wire in and out if you are little handy this is for you
why upgrade for $1000 or $2000 when you can get the same old good service for few more years
This is not direct replacement as you will need to add ground wire and connect wires to the PSB .
but it is relatively simple.
"Cut/clip the wire close to the Power supply Disconnect both connectors, one is the input (high voltage 110 or 120 or 220 ) and one is the supply output (low voltage). They just unclip or cut. and unscrew the 4 screws that secure the power supply to the base of the enclosure. expose ¼” of each end of the wire then you reconnect.
Package includes :
** PSB
** instruction
** Ground wire
specifications:
1.Input features | ||
Ac Input | AC 85-264V | |
DC Output | DC 5/20 | |
Frequency range (Hz) | 47-63 hz | |
Input current (mA) | 1.0/115VAC 0.5/230VAC | |
Inrush Current(A) | Cold start: 10A/230VAC | |
Output efficiency (TYP) | 80% | |
No-load standby (mW) | ≤200mW/230VAC | |
2.OutPut features | ||
Output Voltage (VDC) | 5.0V | |
Output Voltage Accuracy | ±1% | |
Rated current (ADC) | 4000.0mA | |
Rated power (W) | 20W | |
Ripple and noise (MVP - p) Rated input Voltage, 20 MHZ band | ≤100mV | |
Linear adjustment rate (Full load) | ±1% | |
Load regulation (10-100% load) | ±3% | |
Start/ up time | 2s, 30ms/115VAC 1s, 30ms/230VAC | |
Keep time (ms) | 16ms/115VAC 50ms/230VAC | |
Overload protection (Rated input voltage) | Rated output power of 115%-150% Protection mode: hiccup mode, the abnormal condition of abnormal load can be automatically returned | |
Short Circuit Protection (Rated input voltage) | Long short circuit, automatic recovery | |
Over current protection (Rated input voltage) | ≥1.1 times Io | |
Start delay holding time (ms) (Vin:230V AC) | 500ms | |
Loss Electrical ,retention time (ms) (Vin:230V AC) | 20ms |