· This product is an all WHITE body side molding that comes in a 50 foot roll
Installation Instructions:
Do not stretch molding while installing.
1. Temperature of installation surface area and moldings must be
at least 20°C (70°F).
2. Always cut moldings from the chrome side downward.
3. To cut, use anvil type shears (Ronan blade cutter is ideal).
4. Clean area thoroughly with a non-oily general purpose wax and
grease remover – 3M general purpose cleaner followed by isopropyl alcohol is
preferred.
5. Do not touch or contaminate adhesive once liner is removed.
6. Apply moldings on a flat surface only – not on a ridge.
Application:
1. Apply a masking tape guide line to the area molding will be
applied. Do not apply masking to a freshly painted surface.
2. Clean area above masking tape guide using a general purpose
cleaner followed by isopropyl alcohol. Use a clean lint free cloth.
3. Remove 8”-10” of adhesive protective liner at a time and apply
molding using a rolling motion. Check molding clearance with all doors by
opening each carefully. Once the molding is fixed to the car it should not be
removed.
4. Using firm pressure (20-30lbs) rub molding in place with a
molding roller (preferred) or a cloth to pressurize adhesive and ensure a
maximum bond. Press hard with a blunt object on all ends to ensure permanent
adhesion.
Do not expose to heat above 93°C (200°F).