2X( Flames Hydrographic Film Water Transfer Printing Film Hydro Dip Film 50cmX10
2X(1. PREPARATION - Make the item has been stripped of grease, dirt and gunks and other stuff that may interfere with the adhesion of . Durability of any hydrographics coat depends complete and careful preparation of the surface painting. The surface should be even and . Any cracks, and holes or any other imperfections do not let the paint adhere correctly to the surface. Inadequate surface preparation results into majority of failures.
2. PRIMER PAINT - Use the appropriate primer for your substrate. It may whether a metal, plastic, fiberglass, ceramic or wood. your local paint shop for the best option with your market .
3. PAINTING THE BASECOLOR - Paint your preferred basecolor. Most of the patterns are transparent so it a color of would greatly affect your overall output.
4. ACTIVATION & DIPPING - Lay the film in the water. Make the 'sticky side' Remove creases/folds or underneath the print by blowing it lightly. Wait 60-80 seconds activating it. Spray the activator as as much as possible and without too much disturbance on the water. properly activated, submerge your subject by into the water on an angle to avoid trapping .
5. WASH - Wash your dipped item using a running water to the sticky residues left by the print and let it dry for a while.
6. CLEARCOAT - Spray the clearcoat to protect your print and item dry. It would be whether a gloss, a semi-gloss, or a flat finish.
Usage: Use to water transfer printing technology.
Hydrographics or HydroGraphics, also known as immersion printing, water transfer printing, water transfer imaging, hydro dipping, watermarbling or printing, is a of applying to three-dimensional surfaces. The resulting combinations)
2. PRIMER PAINT - Use the appropriate primer for your substrate. It may whether a metal, plastic, fiberglass, ceramic or wood. your local paint shop for the best option with your market .
3. PAINTING THE BASECOLOR - Paint your preferred basecolor. Most of the patterns are transparent so it a color of would greatly affect your overall output.
4. ACTIVATION & DIPPING - Lay the film in the water. Make the 'sticky side' Remove creases/folds or underneath the print by blowing it lightly. Wait 60-80 seconds activating it. Spray the activator as as much as possible and without too much disturbance on the water. properly activated, submerge your subject by into the water on an angle to avoid trapping .
5. WASH - Wash your dipped item using a running water to the sticky residues left by the print and let it dry for a while.
6. CLEARCOAT - Spray the clearcoat to protect your print and item dry. It would be whether a gloss, a semi-gloss, or a flat finish.
Usage: Use to water transfer printing technology.
Hydrographics or HydroGraphics, also known as immersion printing, water transfer printing, water transfer imaging, hydro dipping, watermarbling or printing, is a of applying to three-dimensional surfaces. The resulting combinations)
